Daikin CDX25AVMA [175/268] Indoor outdoor unit installation drawings

Daikin CDK60AVMA [175/268] Indoor outdoor unit installation drawings

Outdoor Units ED12-321A

170 Installation Manual

Indoor/outdoor Unit Installation Drawings

Cut thermal insulation

pipe to an appropriate

length and wrap it with

tape, making sure that no

gap is left in the insulation

pipe’s cut line.

Wrap the insulation

pipe with the finishing

tape from bottom to top.

Caulk

pipe hole

gap

with putty.

(Foot bolt-hole centres)

58cm

Foot bolt-hole

centres

33cm

25 cm from wall

Allow space for piping

and electrical servicing.

Allow 30 cm of work

space below the

ceiling surface.

If there is the danger of the unit falling

or overturning, fix the unit with

foundation bolts, or with wire or other

means.

If the location does not have good

drainage, place the unit on a level

mounting base (or a plastic pedestal).

Install the outdoor unit in a level

position. Failure to do so may result in

water leakage or accumulation.

Level mounting base

(available separately)

Clamping material

Insulation tube

Service lid

Tape

Also insulate the connection on the outdoor unit.

Use tape or insulating material on all connections

to prevent air from getting in between the copper

piping and the insulation tube.

Be sure to do this if the outdoor unit is installed

above.

▲

■

▲■■ ▲

■ ■

▲ ■ ■

▲ ■ ■

▲ ■ ■

20

For installation of the indoor units, refer to the installation manual which was provided with the units.

(The diagram shows a wall-mounted indoor unit.)

● Do not connect the embedded branch piping and the outdoor unit when only carrying out piping work without

connecting the indoor unit in order to add another indoor unit later.

Make sure no dirt or moisture gets into either side of the embedded branch piping.

See “6 Refrigerant Piping Work” in “Outdoor Unit” for details.

● It is impossible to connect the indoor unit for one room only. Be sure to connect at least 2 rooms.

CAUTION

Precautions on Installation

●

Check the strength and level of the installation ground so that the unit will not cause any operating vibration or noise after installed.

●

In accordance with the foundation drawing in fix the unit securely by means of the foundation bolts. (Prepare four sets of

M8 or M10 foundation bolts, nuts and washers each which are available on the market.)

● It is best to screw in the foundation bolts until their length are 20 mm from the foundation surface.

● When installing the unit on the frame, fix water proof plate within 150 mm from the bottom of the unit to prevent water

from entering.

Содержание

Похожие устройства