Tc Electronic G-FORCE [31/63] Utility
![Tc Electronic G-FORCE [31/63] Utility](/views2/1011798/page31/bg1f.png)
29
UTILITY
set by the Mix parameter in each block and “Input/Output”
will mute the direct signal at preset change.
Extern Modifier Input
This function sets how externally controlled parameters
should react at preset change.
Reset -
Will preset the controlled parameter to the value
stored in the preset. At the first movement of the External
controller, the parameter will be captured.
Preserve -
Will preserve the value of the external controller,
meaning that the controlled parameter will start this value.
Example: You are about to load a preset with an external
expression pedal controlling the Delay mix parameter. The
Delay mix parameter is stored at 50%. Now you load this
preset. If you selected “Reset” in the Ext. modifier input,
the Delay mix will be reset to the preset value=50%
If you selected “Preserve” in the Ext. modifier input, the
Delay mix will preserve the pedal value=100%.
Environment
Pedal
Type
Switches between momentary and alternating. This
parameter should be set to alternating if you are using an
expression pedal.
Pedal Calibration
Press Enter to enable calibration of the External input jack
on the back panel of the G-Force. Follow the instructions in
the display.
Pedal Curve
The response curve of the External 1/4” jack Input can now
be adjusted. After the External Input is calibrated, select
“Pedal Curve” in the “Utility - Config display”, and press
ENTER. Use the VALUE wheel to change the response
curve. Press EXIT to leave the “Pedal Curve” display.
The “Pedal Curve” parameter is global, and is therefore not
changed with presets.
T
uner MIDI Out
In the Utility menu, a Tuner MIDI Out parameter is added.
This parameter should be set to “On” to utilize the Tuner-
display function in a connected G•Minor pedal.
The Tuner MIDI Out parameter MUST be set to Off
when performing a MIDI Bulk dump.
If MIDI Out is connected to another device than a G-
Minor it may be advisable to use the “off” position to
avoid sending inappropriate MIDI information to that
device.
User Bank Protect
Protect
Sets the Protect function On/Off.
Protect Low limit
Sets the lower limit of the preset protect. The current
number is included in the protect.
Protect High limit
Sets the higher limit of the preset protect. The current
number is included in the protect.
User Bank Backup
You can backup the User presets of the G-Force to a card
or MIDI recording device using these functions.
Card type: SRAM PCMCIA, type 1, min. 64 K byte.
Depending on the size of the PCMCIA card sveral banks
on a single card is available.
User Bank to Card
Insert a PC-card in the Card slot and press Enter twice. All
User presets of the G-Force will then be saved to the
memory card.
Card to User bank
Insert a PC-card containing your presets and press Enter
twice. All presets will now be stored back into the User
bank of the G-Force.
WARNING: This action will overwrite ALL User presets.
User bank to MIDI
Connect your G-Force’s MIDI out to another G-Force, a
sequencer or any other MIDI recordable device. Press
Enter twice and the G-Force will perform a MIDI bulk dump
of all User presets.
Содержание
- User s manual 1
- Important safety instructions 3
- Important safety instructions 4
- 6 7 8 10 11 12 16 17 18 29 21 25 29 31 32 33 48 49 50 51 52 54 5
- Table of contents 5
- About this manual 7
- Congratulations 7
- Welcome 7
- From a users point of view 8
- Editing 9
- General control 9
- Input output 9
- Quick reference 9
- Quick store 9
- Recall 9
- Setting up an expression pedal 9
- Setting up your midi board 9
- The front panel 10
- The rear panel 12
- The signal flow 13
- How to 14
- How to build a user preset 14
- How to 15
- How to connect the modifiers 15
- How to 16
- How to set up an expression pedal 16
- How to 17
- How to recall a single block from an existing preset 17
- How to set up my midi board 17
- G force setup 18
- Setups 18
- General 19
- Recall 19
- Recalling a preset 19
- Recalling a single effect 19
- The recall display 19
- Delete 20
- Store a new user preset 20
- The letterbox 20
- Using a memory card 20
- Effects 21
- Editing an effect 22
- Effects 22
- I o setup 23
- I o setup 24
- Ext controllers 25
- I o setup 25
- How the modifiers are connected 26
- I o setup 26
- Setting up an expression pedal 26
- Matrix 27
- Modifier 27
- Envelope follower 28
- Modifier 28
- Modifiers 28
- Adsr 1 2 29
- Lfo 1 2 29
- Modifier 29
- Config 30
- Modifier utility 30
- Utility 30
- Utility 31
- Billboard 32
- Utility 32
- The tuner display 34
- Algorithms 35
- The blocks 35
- Compressor 36
- Filters 36
- The blocks 36
- Parametric equalizer 37
- Resonance 37
- The blocks 37
- Formant filters 38
- The blocks 38
- Wah wah 38
- Pan trem block 39
- Phaser 39
- The blocks 39
- Tremolo 39
- Panner 40
- The blocks 40
- The blocks 41
- The pitch block 41
- Fixed 1 2 voice pitch 42
- The blocks 42
- Voice 2 octave 42
- Detune 43
- Stereo delay 43
- The blocks 43
- The blocks 44
- Dual two tap delay 45
- The blocks 45
- One tap delay 46
- The blocks 46
- Quad tap delay 47
- The blocks 47
- The drive 47
- Classic chorus 48
- The blocks 48
- The chorus flanger block 48
- Advanced chorus 49
- Flanger classic 49
- The blocks 49
- Advanced flanger 50
- The blocks 50
- The blocks 51
- The reverb block 51
- The blocks 52
- Output 53
- Simple reverb 53
- The blocks 53
- How to enter the reset page 54
- The reset page 54
- Technical specifications 55
- Troubleshooting 56
- Midi implementation chart 57
- Self test 58
- Preset list 59
- Preset list 60
- Preset list 61
- Preset list 62
- Preset list 63
Похожие устройства
- Hertz HP 2 Инструкция по эксплуатации
- Casio EX-Z800 Black Инструкция по эксплуатации
- Maxwell MW-1003 Инструкция по эксплуатации
- Champion LM5126BS Инструкция по эксплуатации
- Toshiba SD-63HK Инструкция по эксплуатации
- Hertz HP 1 D Инструкция по эксплуатации
- Gree Bee Plasma GWH24ND-K3NNB3B Инструкция по эксплуатации
- Tc Electronic G-MAJOR Инструкция по эксплуатации
- Casio EX-ZS5 Black Инструкция по эксплуатации
- Mega 4120 XAS Инструкция по эксплуатации
- Maxwell MW-1012 Инструкция по эксплуатации
- Toshiba SD-57HTKR Инструкция по эксплуатации
- Hertz HP 1 KD Инструкция по эксплуатации
- Tc Electronic G-SHARP Инструкция по эксплуатации
- Casio EX-ZS10 Pink Инструкция по эксплуатации
- Champion 3053-C2 Инструкция по эксплуатации
- Toshiba SD-47HKSR Инструкция по эксплуатации
- Pandora программирование брелков Инструкция по эксплуатации
- Tc Electronic G-SYSTEM Инструкция по эксплуатации
- Hertz Hertz HE 2 Инструкция по эксплуатации
Скачать
Случайные обсуждения