Kramer VP-440 [13/59] Connecting the vp 440

VP-440 - Connecting the VP-440

4 Connecting the VP-440

Always switch off the power to each device before connecting it to

your VP-440. After connecting your VP-440, connect its power and

then switch on the power to each device.

You do not have to connect all the inputs and outputs, connect only

those that are required.

To connect the VP-440, as illustrated in the example in Figure 3, do the following:

1. Connect an HDMI source (for example, a BluRay disk player) to the HDMI 1

(H1) VIDEO INPUT connector (from 1 to 4).

Alternatively, you can connect the DVI connector on the DVD player to the HDMI

connector on the VP-440 via a DVI-HDMI adapter. When using this adapter, you can

connect the audio signal via the terminal block connector

2. Connect a computer graphics source to the PC 1 15-pin HD VIDEO INPUT

connector (from 1 to 2).

3. Connect the audio input signals to the AUDIO INPUT 3.5mm mini jack

connectors, as required (not shown in Figure 3).

4. Connect the HDMI OUT connector to an HDMI acceptor (for example, an

LCD display).

5. Connect the HDBT OUT connector to an HDBT receiver (for example, the

output of TP-580R connected to HDBT).

6. Connect the AUDIO OUT 3.5mm mini jack connector to an unbalanced stereo

audio acceptor (not shown in Figure 3).

7. On the front panel, connect a microphone to the MIC 6.5mm phone jack and

set it to condenser or dynamic type.

8. Connect the power cord (not shown in Figure 3).