Telwin MOTOTRONIC 6/12 [2/40] Battery charger

Telwin MOTOTRONIC 6/12 [2/40] Battery charger
3. DESCRIPTION OF THE BATTERY CHARGER
_______________( GB )_____________
Control, adjustment and indicator devices.
INSTRUCTION MANUAL
RED LED - Polarity inverted. Danger!!!
YELLOW LED - Charging in progress.
GREEN LED - End of charging.
WARNING: BEFORE USING THE BATTERY CHARGER
READ THE INSTRUCTION MANUAL CAREFULLY.
.
GREEN LED - Correct power supply.
1. GENERAL SAFETY RULES WHEN USING THIS
__________________________________________________________________________________
BATTERY CHARGER
BYPASS BUTTON
If the battery is too flat (with a voltage less than 70% of
the rated value) charging is not carried out (YELLOW
LED off). Press the BYPASS button for several seconds,
- During the charge the battery produces explosive gases,
then release the button and see if the YELLOW LED stays
avoid the formation of flames and sparkes. DO NOT
on.
SMOKE.
Controlled charging by the electronic board has been
- Position the batteries to be charged in a well-ventilated
restored.
place.
The battery cannot be recharged if, after holding the
button in the BYPASS position for several minutes, the
YELLOW LED goes off when the button is released.
- Inexperience and untrained people should be properly
WARNING! NEVER EVER LOCK THE BUTTON IN THE
instructed before using the appliance.
BYPASS POSITION! THIS COULD DAMAGE THE
- People (children included) whose physical, sensory or
BATTERY AND THE BATTERY CHARGER!
__________________________________________________________________________________
mental capacities would prevent them from using the
appliance correctly must be supervised by a person
who is responsible for their safety while the appliance
4. INSTALLATION
is in use.
POSITIONING THE BATTERY CHARGER
- Children must be supervised to ensure that they do
- During operation, position the battery charger on a stable
not play with the appliance.
surface and make sure that there is no obstruction to air
- Use the battery charger only indoors and make sure that
passage through the openings provided to ensure
you start it in airy places. DO NOT SET IN THE RAIN OR
sufficient ventilation.
SNOW.
- Disconnect the mains cable before connecting to or
CONNECTION TO POWER
disconnecting the charging cables from the battery.
- The battery charger should be connected only and
- Do not connect or disconnect the clamps to or from the
exclusively to a power source with the neutral lead
battery with the battery charger operating.
connected to earth.
- Never use the battery charger inside the car or in the
Check that the net voltage is the same as the voltage of the
bonnet.
equipment.
- Substitute the mains cable only with an original one.
- Check that the power supply is protected by systems as
- Do not use the battery charger to charge batteries which
fuses or automatic switches, sufficient to support the
are not rechargeable.
maximum absorption of welding.
- Make sure the available power supply voltage
- If you put an extension to the primary cable, the diameter
corresponds to that shown on the battery charger rating
must be the same, never inferior.
plate.
- The connection to the power has to be made using the
- To avoid damaging the vehicle's electronics, read, keep
cable.
and take very careful note of the information supplied by
the vehicle manufacturer, when using the battery charger
5. OPERATION
either for charging or starting; the same applies to the
BEFORE CHARGING
instructions supplied by the battery manufacturer.
NB: Before charging check that the capacity of the
- This battery charger has components such as switches
battery (Ah) which is to be charged, is not inferior to that
and relays which can cause arcs or sparks. Therefore
reported on the data table. (C min).
when using it in a garage or in a similar place set the
Follow the instructions, taking great care to respect the
battery charger in a suitable case.
order given below.
- Repair or maintenance of the inside of the battery charger
- Remove the caps of the battery charger (if foreseen) so as
can be executed only by skilled technicians.
to let the gas produced go out.
- WARNING: ALWAYS DISCONNECT THE POWER
- Check that the level of the electrolyte covers the plates of
SUPPLY CABLE FROM THE MAINS BEFORE
the battery. If these were not covered add distilled water
CARRYING OUT ANY SIMPLE MAINTENANCE
and cover them up to 5-10 mm.
OPERATION ON THE BATTERY CHARGER.
2. I N T R O D U C T I O N A N D G E N E R A L
WARNING: USE THE MAXIMUM CAUTION DURING
DESCRIPTION
THIS OPERATION AS THE ELECTROLYTE IS A HIGHLY
- This battery charger can be used to charge free electrolyte
CORROSIVE ACID.
lead acid batteries used on petrol and diesel engine
- With the power supply cable disconnected from the power
vehicles, motor cycles, boats etc. and is suitable for
outlet, position the 6/12 V or 12/24 V charge switch (if
charging sealed batteries.
present) according to the rated voltage of the battery to be
- Rechargeable batteries according to the output voltage
charged.
available: 6V / 3 cells; 12V / 6 cells; 24V / 12 cells.
- Check the polarities of the battery terminals: positive for
- The charging current delivered by the battery decreases
the + symbol and negative for the - symbol.
according to the characteristic W bend - see the DIN
NOTE: if the symbols are indistinguishable remember that
41774 norm.
the positive terminal is the one not connected to the
vehicle chassis.
- 2 -

Содержание

Похожие устройства

Скачать