Nissan Note [6/34] Fuel level sensor unit fuel filter and fuel pump assembly

FL-6

[CR]

FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY

10. Install lock ring temporally by hand tightening until it stops with

maximum force.

● Direct arrow mark on lock ring to vehicle rear. Then turn clock-

wise to tighten lock ring.

CAUTION:

Do not remove lock ring until fuel level sensor unit, fuel fil-

ter and fuel pump assembly is installed.

11. Remove fuel level sensor unit in the following procedures.

a. Remove harness connector (brown).

● Hold connector with your fingers, because there is no tab for

releasing stopper. Pull it out straight downward.

b. Insert a screwdriver into the gap between fuel level sensor unit

left side and mounting part. Pry the screwdriver in the direction

shown by arrow.

CAUTION:

Be careful not to damage anything.

c. When fixing tab comes off, slide fuel level sensor unit in the

direction indicated by arrow to remove.

CAUTION:

● Do not reuse removed fuel level sensor unit.

● Do not disassemble fuel filter and fuel tank pump assem-

bly.

INSTALLATION

Install in the reverse order of removal which being careful of the following.

Installation of Fuel Level Sensor Unit

Install it in the following procedures.

1. Check fuel gauge mounting part of fuel filter and fuel pump assembly side for damage.

2. Slide fuel level sensor unit along with mounting groove. Insert new fuel level sensor unit until it contacts

the face.

● After inserting, apply force to the reverse direction (removal direction). Make sure fuel level sensor unit

does not come off.

3. Connect harness connector.

● Insert harness connector securely until it contacts the face.

Installation of Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly

Install it in the following procedures.

1. Remove lock ring.

2. Install O-ring to fuel tank without any twist.

PBIC1573E

PBIC1500E

PBIC1501E