Nissan Note [7/34] Fuel level sensor unit fuel filter and fuel pump assembly

FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY

FL-7

[CR]

3. Install fuel level sensor unit, fuel filter and fuel pump assembly,

aligning the sender unit rear side protrusion with the fuel tank

opening rear side cutout.

CAUTION:

● Do not allow O-ring to drop.

● Maintain closely jointed status by pressing fuel level sen-

sor unit, fuel filter and fuel pump assembly at an opening

of the tank until the end of step 5, in order to prevent the

fallout of O-ring (To maintain the O-ring installed status of

view A in the figure at step 2).

4. Direct arrow mark on lock ring to vehicle rear. Then turn lock ring

clockwise by hand until it steps with maximum force.

CAUTION:

Install lock ring horizontally.

5. Tighten lock ring to the specification with lock ring wrench [SST:

KV993G0010].

Fuel Feed Hose Installation

● Connect quick connector in the following procedures.

1. Check connections for damage or foreign material.

2. Align the mating side connection part with the center of shaft on

the sender unit, and insert quick connector straight until it clicks.

3. After connecting, pull out quick connector by hand. Make sure

connections are secure.

INSPECTION AFTER INSTALLATION

● Check for fuel leak in the following procedures.

1. Turn the ignition switch to ON (do not start engine), and with fuel pressure applied in the fuel line, check to

make sure there are no fuel leaks from the connection.

2. Start the engine, and at increased speed, check again to see if there any fuel leaks from the connection.

PBIC1502E

PBIC1573E

PBIC1503E