AMERICAN DJ Vizi Beam RXONE [18/22] Master slave operation

ADJ Products, LLC - www.adj.com - Vizi Beam RXONE Instruction Manual Page 35ADJ Products, LLC - www.adj.com - Vizi Beam RXONE Instruction Manual Page 34

The UC IR (sold separately) infrared remote gives you control of

various functions (See below). To control the fixture you must aim the

remote at the front of the fixture and be no more than 30 feet away.

Please see below for IR functions.

The Airstream IR (sold separately) remote transmitter plugs into

the headphone jack of your iOS phone or tablet. To control your IR

fixture you must raise the volume to the maximum on your iOS phone

or tablet and aim the transmitter at the fixture sensor and be no more

STAND BY - Pressing this button will blackout the fixture. Press the

button again to return to the initial state.

FULL ON - Hold this button down to fully light up the unit. When you

let the button go, the unit will return to its previous state.

FADE/GOBO - This button activates gobo selection. Press this but-

ton and use buttons 1-9 to find your desired gobo.

“DIMMER +” and “DIMMER -” - These buttons are used to adjust

the output intensity in static color mode.

STROBE - Press and hold this button for strobing.

to find your desired show.

units together and operate without a controller. The units will be sound

activated. In Master-Slave operation one unit will act as the controlling

unit and the others will react to the controlling units programs. Any unit

can act as a Master or as a Slave.

1. Using approved DMX data cables, daisy chain your units togeth-

2. On the Master unit press the MENU button until “Slave Mode” is

displayed, and press ENTER. Use the UP and DOWN buttons to

scroll to the “Master” setting and press ENTER.

3. After setting the Master unit to the master setting find and set

your desired operating mode.

4. On the slave units press the MENU button until “Slave Mode” is

displayed, and press ENTER. Choose either “Slave 1” or “Slave

2” and press ENTER.

5. The slave units will now follow the Master unit.

Sound Active Mode: This mode allows either single unit or several

sensitivity. Press ENTER when you have found your desired sensi-

tivity level.

Show Mode: This mode allows either a single unit or several units

linked together, to run one of four shows that you choose.

1. Press the MENU button until “Show Mode” is displayed, and

press ENTER.

2. Press the UP or DOWN buttons to nd your desired show, and

press ENTER.