Honda CBR600F2 (1991-1994) [106/196] Right handlebar removal installation

Содержание

Похожие устройства

Front Wheei Suspension Steering Right Handlebar Removal Installation A WARNING Contaminants in the system may cause a reduction or loss of braking ability CAUTION _______ Spilled brake fluid will damage painted plastic or rubber parts Requisite Service Throttle grip free play adjustment Refer to section 2 ol the Common Service Manual Air cleaner housing removal instailation page 6 3 Procedure Q ty 2 1 Master cylinder assembly Right handlebar switch housing screw 5 Right handlebar switch housing 6 Throttle cable end carburetor side 7 Throttle cable nut 8 Throttle cable end throttle pipe side 9 Handlebar weight 10I Throttle pipe 11 Throttle grip 1 2 1 1 1 2 1 1 1 12 Stopper ring 13 Handlebar pinch bolt 14 Right handlebar 1 1 1 1 2 3 w 12 2 Remarks Installation is in the reverse order of removal Removal Order Front brakelight switch connector Master cylinder holder Align the holder mating surface with the punch mark on the handlebar and install the holder with the UP mark upward Tighten the front screw first then the rear one Align the tang of the housing with the hole in the handlebar Don t bend the cables too much Align its boss with the inner weight Apply Honda Bond A or an equivalent to the inside surface of the grip Tighten the pinch bolt while pushing the handlebar forward Align the handlebar boss with the top bridge slot