Главная
Skipped breadcrumb items
rbc411u
Инструкция по эксплуатации Страница: 16

Главная
Makita
rbc411u
Инструкция по эксплуатации Страница: 16

Makita rbc411u — полный план обслуживания для эффективной работы оборудования [16/68]

Превью страниц Страница 16 / 68

Makita rbc411u [16/68] Maintenance schedule

1. Before operation, pay particular attention to the tightness of Cutter Blade or

nylon cutting head.

Check bolts and nuts and retighten if necessary.: Every 8 hour (Daily)

2. Check clogging of the cooling air passage and the cylinder fins. Clean them

if necessary.: Every 8 hours (Daily)

3. Cleaning of air cleaner.: Every 8 hours (Daily)

1) Remove the air cleaner cover (1) and clean the sponge element (2).

If there is excessive dust or dirt adhering to cleaner, clean it.

A clogged air cleaner may make it difficult or impossible to start the

engine or increase the engine rotational speed.

2) Install the sponge element around the ribs of the air cleaner case.

4. Checkup of spark plug.: Every 8 hours (Daily)

The gap between the two electrodes of the spark plug should be 0.6 to

0.7 mm (0.024" to 0.028").

If the gap is too wide or too narrow, adjust it.

If the spark plug is clogged with carbon or fouled, clean it thoroughly or

replace it.

5. Supply of grease to gear case.

Apply grease (SHELL ALVANIA No.3 or equivalent) to the gear case through

the grease hole (3) every 30 hours.

(Genuine MAKITA grease may be purchased from your MAKITA dealer.)

6. Cleaning of muffler exhaust port: Every 50 hours (Monthly)

If the exhaust port (4) is clogged with carbon, remove it by scraping and

tapping gently with a screwdriver or the like.

7. Check of fuel filter. If clogged, clean the filter.

8. Replace fuel lines.: Every 200 hours (Yearly)

9. Overhaul engine.: Every 200 hours (Yearly)

10. Replace packings and gaskets with new ones.: Every time engine is

reassembled.

Maintenance schedule

General

Engine assembly, screws and nuts

Visual inspection for damage and tightness

Check for general condition and security

After each refuelling Throttle lever

Safety lock key

ON-OFF switch

Functional check

Daily Sponge element (air filter)

Cooling air duct

Cutting blade

Idling speed

To be cleaned

Check for damage and sharpness

Inspection (cutting tool must not move)

Weekly Spark plug

Muffler

Inspection, replace if necessary

Check and if necessary clean the opening

Quarterly Suction head (gas line filter)

Fuel tank

To be replaced

To be cleaned

Shutting down procedure Fuel tank

Carburetor

Empty fuel tank

Operate until engine runs out of fuel

0. 6mm-0.7 mm

(0.024”-0.028”)

Grease case

(3)

(4)

Makita rbc411u — полный план обслуживания для эффективной работы оборудования [16/68]

Содержание

Похожие устройства