Moxa MPC-2150Z-T [22/65] Connecting data transmission cables

MPC-2150 Hardware Hardware Connection Description

3-9

Connecting Data Transmission Cables

This section describes how to connect the MPC-2150 panel computer to a network, or serial devices.

Connecting to a Network

Plug an Ethernet cable into the MPC-2150’s Ethernet port. The other end of the cable should be plugged into

your Ethernet network. When the cable is properly connected, the LEDs on the panel computer’s Ethernet port

will glow to indicate a valid connection. See the following figure for the location of the Ethernet ports.

The 10/100/1000 Mbps Ethernet LAN port uses 8-pin RJ45 connectors. The following diagram shows the

pinouts and the descriptions for these ports.

LAN (on connectors)

Green 100 Mbps Ethernet mode

Yellow 1000 Mbps (Gigabit) Ethernet mode

Off No activity or 10 Mbps Ethernet mode

Pin 100 Mbps 1000 Mbps

1 ETx+ TRD(0)+

2 ETx- TRD(0)-

3 ERx+ TRD(1)+

4 – TRD(2)+

5 – TRD(2)-

6 ERx- TRD(1)-

7 – TRD(3)+

8 – TRD(3)-