Trotec ProMarker 300 [15/43] Before commissioning

Promarker

Operation Manual

09/01/2012 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support 15 / 43

tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, e-mail: techsupport@troteclaser.com

5 Before Commissioning

• Read the operation manual and ensure it is accessible at all times.

• The ambient air temperature must be between +15°C und +35°C

and the relative air humidity not exceed 90% (non-condensing).

• A laser system consists of high quality electrical and optical

components. Mechanical stresses, vibrations and impacts must

always be avoided.

• If the system has been subject to significant temperature

variations, it must be brought back to room temperature before

being commissioned.

• Sufficient air must be supplied to the 19” module of ventilated

systems. The accumulation of heat due to covered ventilation slots

or filter pads can damage the system.

• Assemble the device at the point of installation according to the

instructions.

• The operating personnel must read and understand the operation

manual, in particular the chapter on “Safety Instructions”. It is

recommended that the operator compiles with in-house

instructions regarding safety and operation and that the receipt of

these instructions/operation manual and the participation in

briefings/training courses is confirmed in writing.

• Laser marking may generate gases, fumes and other reaction

products on the surface of the material. The operator must

therefore use an effective extraction system.