D-Link DGS-6604 [1002/1106] Example

D-Link DGS-6604 [1002/1106] Example
DGS-6600 Series Switch m speed
CLI Reference Guide
992
Auto-negotiation will be enabled whether the speed is set to auto or duplex is set
to auto. If the speed is set to auto, and duplex is set to fixed mode, then only the
speed will be negotiated. The advertised capability will be the configured duplex
mode combined with all possible speeds. If speed is to set to a fixed speed and
duplex is set to auto, then only duplex mode is negotiated. The advertised
capability will consist of both the full and half duplex mode combined with the
configured speeds.
Before adding ports to a Port-Channel, verify that all settings are the same on
these ports. Otherwise the ports in a Port-Channel with different settings will
operate in an indeterminate manner.
In IEEE 802.3 (clause 40) 1000BASE-T standard, Auto-Negotiation is defined as
necessary. Although a command was provided to disable auto-negotiation for
1000Base-T, setting it to enable is recommended to prevent an unexpected link
status.
For combo port interfaces, the user must assign the medium type for the
configuration.
Example This example shows how to configure interface eth3.24 to force the settings to a
speed of 100Mbits and auto-negotiate to the duplex mode.
This example shows how to set eth3.1 to speed auto on copper with combo port.
Verify the settings by entering the show interface command.
Switch(config)# interface eth3.24
Switch(config-if)# speed 100
Switch(config-if)# duplex auto
Switch(config)# interface eth3.1
Switch(config-if)# speed auto copper

Содержание

Скачать