D-Link DGS-6604 — команда для отображения MPLS таблицы пересылки в сетевых устройствах [874/1106]

Превью страниц Страница 874 / 1106

DGS-6600 Series Switch m show mpls forwarding-table (VPWS)

CLI Reference Guide

864

show mpls forwarding-table (VPWS)

Use this command to show the MPLS label forwarding path information.

show mpls forwarding-table [vc VC-ID IP-ADDRESS] [detail]

Default N/A.

Command Mode Exec mode or any configuration mode.

Usage guideline This command shows the MPLS forwarding path information, including the FTN

and ILM entries.

Note: If the status didn’t work, the information would be “N/A” or not shown.

Example This example shows all MPLS label forwarding path information.

In the above example, LSP 5 is the outbound LSP of the VC FEC whose VC ID is

11 and peer is 192.1.1.1.

It pushes VC label 100 and tunnel label 70. The inbound LSP of the VC FEC is

LSP 6. It pops incoming VC label 200 and forwards the terminated packets to

Ethernet port 5.

This example shows all detail MPLS label forwarding path information.

Syntax Description

vc VC-ID IP-

ADDRESS

(Optional) Specifies VC FEC. If none are specified, all FEC’s are shown.

detail Show the detailed information of the MPLS label forwarding path information.

Switch# Show mpls forwarding-table

LSP FEC In Label Out Label Out Interface Next Hop

---- ------------- -------- --------- ------------- ---------------

1 201.1.1.0/24 20 swap 30 vlan 10 172.18.1.1

2 201.2.1.0/24 60 swap 40 vlan 20 192.1.1.2

3 172.1.1.1/32 50 pop vlan 10 172.18.1.1

4 192.1.1.0/24 - push 70 vlan 10 172.18.1.1

5 VC11/192.1.1.1 - push 100/70 vlan 10 172.18.1.1

6 VC11/192.1.1.1 200 pop eth1.5 -

Total Entries: 6