D-Link DGS-6604 [1060/1106] Command mode

D-Link DGS-6604 [1060/1106] Command mode
DGS-6600 Series Switch m vlan-tunnel
CLI Reference Guide
1050
vlan-tunnel
Use this command to enable the VLAN tunnel mode. Use the no form of the
command to disable the VLAN tunnel mode. VLAN tunnel is also called QinQ
and it includes VLAN translation feature.
vlan-tunnel
no vlan-tunnel
Syntax None.
Default Disabled.
Command Mode Global configuration.
Usage Guideline This command enables VLAN tunneling mode. To turn VLAN tunneling mode
from disabled to enabled state, GVRP must be disabled first.The default setting
of VLAN tunneling mode is applied with the following setting:
1. All interfaces are set as Network-to-Network Interfaces (NNI) port.
2. All existing static VLANs will run as SP-VLANs. All dynamically learned L2
addresses will be cleared.
3. All dynamically registered VLAN entries will be cleared.
4. In order to run GVRP on the switch, enable GVRP manually. In VLAN tunnel
mode, the SP-VLAN GVRP Address (01-80-C2-00-00-0D) will be used by the
GVRP protocol.
Example This example shows how to enable the VLAN tunnel mode.
Verify the settings by entering show vlan-tunnel command.
Switch# configure terminal
Switch(config)# vlan-tunnel
Switch(config)#

Содержание

Скачать