D-Link DGS-6604 — настройка состояния Spanning Tree на интерфейсе коммутатора [985/1106]

Превью страниц Страница 985 / 1106

DGS-6600 Series Switch m spanning-tree state (Interface configuration)

CLI Reference Guide

975

spanning-tree state (Interface configuration)

This setting is used to configure the STP function on the specified port. Use the

no form of the command to reset to the default.

spanning-tree state {enable | disable}

no spanning-tree state

Syntax None.

Default Enabled.

Command Mode Interface configuration.

Usage Guideline When setting the interface with the spanning-tree state disable command, the

interface will not participate in the spanning tree topology port state calculation.

If the global spanning-tree state is disabled (no matter STP is disabled/enabled

at the interface), then STP BPDU is treated as a normal multicast packet and will

be flooded to the other VLAN member ports.

If the global spanning-tree state is enabled, then the STP state at the interface

must be enabled, then the interface can participate in the STP calculation.

Both physical ports and channel group are valid interfaces for this command.

Example This example shows how to configure the STP state for interface port eth1.7.

Verify the settings by entering the show spanning-tree interface command.

Prompt message at screen

Description

Can not enable STP on the port as it is LBD

enabled.

STP and LBD should be mutually exclusive

on the same port.

Switch(config)# interface eth1.7

Switch(config-if)# spanning-tree state enable