D-Link DGS-6604 — настройка доступа VLAN для интерфейсов коммутаторов [49/1106]

Превью страниц Страница 49 / 1106

DGS-6600 Series Switch m access vlan

CLI Reference Guide

access vlan

Use the access vlan interface configuration command to specify the access

VLAN for the interface. Use default interface command to reset to default setting.

access vlan VLAN-ID

default access vlan

Default VLAN 1.

Command Mode Interface configuration mode.

Usage Guideline Physical ports or port-channels are the only valid interfaces for this command.

If a VLAN does not exist, the VLAN will be automatically created and prompt a

message displayed. By default the port has access VLAN 1.

An interface can be specified with only one access VLAN; the succeeding

command overwrites the previous command.

When this command is applied, the port will change to Access mode; the setting

for other modes will disappear and the port's PVID will be changed to the

specified VLAN.

As an access port the port will classify the untagged packet with the access

VLAN which are classified by the protocol-based VLAN, MAC-based VLAN etc.

Examples This example shows how to set an interface port 1.1 to an untagged member of

VLAN 1000.

Verify the settings by entering the show vlan interface command.

Syntax Description

access vlan VLAN-ID Specifies the VLAN for the interface.

Switch(config)# interface eth1.1

Switch(config-if)# access vlan 1000