D-Link DGS-6604 [258/1106] Usage guideline

Превью страниц Страница 258 / 1106

DGS-6600 Series Switch interface

CLI Reference Guide

248

interface

Enter the interface command to go into interface configuration mode. The

command executed in this mode will be applied to the interface specified by the

command. use the no form of this command to remove an interface.

interface INTERFACE-ID

no interface INTERFACE-ID

Default None.

Command Mode Global configuration.

Usage Guideline The interface command puts the command line interface into interface

configuration mode for a specified interface.

For the port-channel interface, it must be an existing channel-group.

Use interface vlan command to create a VLAN interface (Layer 3 interface). Use

the vlan command in global configuration mode to create a VLAN before creating

VLAN interfaces. Use the no interface vlan command to remove a VLAN

interface. Only the VLAN interface is allowed for the no form of the command.

For the loopback interface, it must be one of the loopback interface provided by

the system. The number of supported loopback interface is project dependant.

Example This example shows how to enter the interface configuration mode for eth3.5:

In the following example, the user enters interface configuration mode for VLAN

100. The vlan100 interface will be created if it does not exist before:

Syntax Description

INTERFACE-ID The interface can be a physical port, port-channel, VLAN or loopback interface.

Switch(config)# interface eth3.5

Switch(config-if)#

Switch(config)# interface vlan100

Switch(config-if)#