D-Link DGS-6604 — справочник по сбросу параметров 802.1X для коммутаторов [203/1106]

Превью страниц Страница 203 / 1106

DGS-6600 Series Switch mm dot1x default

CLI Reference Guide

193

dot1x default

Using this command resets the configurable 802.1X parameters to the default

values.

dot1x default

Syntax

Description

None.

Default The default values are listed below:

The authorization state on a controlled port is auto.

The direction of the traffic through a controlled port is bidirectional.

The number of maximum retransmit times which the switch will retransmit an

EAP request frame to the supplicant before restarting the authentication process

is 2.

quiet-period: 60,

reauth-period: 3600

server-timeout: 30

supp-timeout: 30

tx-period: 30

Periodic re-authentication is disabled.

Command Mode Interface configuration.

Usage Guideline This command is only valid on physical port interfaces.

Example The following example shows how to reset the IEEE 802.1X parameters on port

eth4.1.

Verify the settings by entering the show dot1x auth-configuration command.

Switch# configure terminal

Switch(config)# interface eth4.1

Switch(config-if)# dot1x default