Tp-Link T1700G-28TQ V2 — настройка IPv6 MLD Snooping для динамических групп Multicast [271/354]

Превью страниц Страница 271 / 354

the default of no limitation on the specified port, please use the no ipv6 mld

snooping max-groups command. To return to the default action of dropping

the report, please use the no ipv6 mld snooping max-groups action

command. These commands only apply to the dynamic multicast groups.

Syntax

ipv6 mld snooping max-groups [

maxgroup

]

ipv6 mld snooping max-groups action { drop | replace }

no ipv6 mld snooping max-groups

no ipv6 mld snooping max-groups action

Parameter

maxgroup

—— Specify the maximum numbers of groups that the port can

join. It ranges from 0 to 1000 and the default value is 1000.

drop

—— When the number of the dynamic multicast groups that a port joins

has exceeded the max-group, the port will not join any new multicast group.

replace

—— When the number of the dynamic multicast groups that a port

joins has exceeded the max-group, the newly joined multicast group will

replace an existing multicast group with the lowest multicast group address.

Command Mode

Interface Configuration Mode (interface gigabitEthernet / interface range

gigabitEthernet / interface ten-gigabitEthernet / interface range

ten-gigabitEthernet)

Privilege Requirement

Only Admin and Operator level users have access to these commands.

Example

Specify the maximum numbers of groups that ports 1/0/2-5 can join as 10,

and configure the throttling action as replace:

T1700G-28TQ(config)#interface range gigabitEthernet 1/0/2-5

T1700G-28TQ(config-if-range)#ipv6 mld snooping max-groups 10

T1700G-28TQ(config-if-range)#ipv6 mld snooping max-groups action

replace

255