Tp-Link T1700G-28TQ V2 — настройка LLDP-MED на гигабитном Ethernet порту [307/354]

Превью страниц Страница 307 / 354

Example

Exclude “management-address” and “port-vlan-id” TLVs in LLDPDU outgoing

from Gigabit Ethernet port 1/0/1:

T1700G-28TQ(config)# interface gigabitEthernet 1/0/1

T1700G-28TQ(config-if)# no lldp tlv-select management-address port-vlan

30.8 lldp med-fast-count

Description

The lldp med-fast-count command is used to configure the number of the

LLDP-MED frames that will be sent out. When LLDP-MED fast start

mechanism is activated, multiple LLDP-MED frames will be transmitted based

on this parameter. The default value is 4. To return to the default

configuration, please use no lldp med-fast-count command.

Syntax

lldp med-fast-count

count

no lldp med-fast-count

Parameter

count

—— Configure the Fast Start Count parameter. It ranges from 1 to 10.

By default, it is 4.

Command Mode

Global Configuration Mode

Privilege Requirement

Only Admin and Operator level users have access to these commands.

Example

Specify Fast Start Count as 5:

T1700G-28TQ(config)# lldp med-fast-count 5

30.9 lldp med-status

Description

The lldp med-status command is used to enable the LLDP-MED feature for

the corresponding port. After the LLDP-MED feature is enabled, the port's

Admin Status will be changed to Tx&Rx. To disable the LLDP-MED feature for

the corresponding port, please use no lldp med-status command.

291