![Nilfisk SH AUTO 5M [28/33] Trouble shooting](/img/pdf.png)
Nilfisk SH AUTO 5M [28/33] Trouble shooting
![Nilfisk SH AUTO 5M [28/33] Trouble shooting](/views2/1514922/page28/bg1c.png)
28
AUTO BOOSTER
Original Instructions
6 Trouble Shooting
You have chosen the best quality and therefore deserve the best service. The AUTO BOOSTER
features an “Error detection system” that will stop the AUTO BOOSTER in case of a severe error that
needs immediate attention. The display in the inspection window (12) will indicate the nature of the
error.
Though the user can correct some of these errors, you should note the error and contact the nearest
Nilfi sk-ALTO service organization. To avoid unnecessary disappointments, you should check this sec-
tion before contacting the nearest Nilfi sk-ALTO service organization.
6.1 General trouble shooting
Symptom Reason Action
Machine will not start > A fuse has blown • Change the fuse.
(NO ERROR indication) > Power disconnected • Connect power (HPFI).
Fuses blow > Installation does not • Change to an installation.
correspond to the ampere corresponding to the ampere
consumption of the machine consumption of the machine
at a minimum.
Change the fuse.
Working pressure too low > Nozzle worn • Replace the nozzle.
> Wrong spray lance • Replace the spray lance
(see section 4.1.4).
No detergent > Detergent container empty • Fill up with a detergent.
> Filter in container clogged up • Clean the fi lter.
Working pressure fl uctuating > Air in the system • Vent the system
(see section 3.7).
> Detergent container empty • Fill up with a detergent.
> Water inlet fi lter clogged up • Clean fi lter (see sect. 5.4).
No working pressure > Nozzle clogged up • Clean nozzle (see sect. 5.5).
> No inlet water • Check that the shut off cock
of the water inlet is open.
Check that the water supply
meets the requirements
(see section 3.4).
> Water inlet fi lter clogged up • Clean fi lter (see sect. 5.4).
Machine starts and > Leaky hose/ • Repair leak.
stops pipeline/spray handle
> Water shortage • Check the water supply -
open ? suffi cient pressure ?
Check and clean the water
inlet fi lter (see sect. 5.4).
Содержание
- Auto booster 1
- Operating instructions 1
- Auto booster 3
- Contents 3
- Declaration of conformity 1 3
- Description 3
- Installation 3
- Maintenance 4 3
- Operation 2 3
- Safety precautions and warnings 3
- Technical data 0 3
- Trouble shooting 8 3
- Warranty 1 3
- Auto booster 4
- Safety precautions and warnings 4
- Auto booster 5
- Auto booster 6
- Description 6
- Auto booster 7
- Installation 7
- Auto booster 8
- Auto booster 9
- Auto booster 10
- Auto booster 11
- Auto booster 12
- Operation 12
- Auto booster 13
- Auto booster 14
- Auto booster 15
- Auto booster 16
- Maintenance of coin selector the coin selector should be cleaned at regular intervals especially if it is operating in an environment with high levels of dust smoke or nicotine the cleaning intervals are of course dependent on the level of air borne contaminants 16
- Minimum price setting use pins to set minimum price 16
- Modest use with minimum contaminant levels indicates the need to clean the top of the coin path once a year open the coin path door and wipe the exposed surfaces with an alcohol moistened cloth the light sensors may be cleaned with a soft brush or air spray duster 16
- Original instructions 16
- See below table for coin selector 16
- Switch 3 switch 4 16
- Time setting use pins to set time value of minimum price 16
- Auto booster 17
- For water hardness s between 10 ºdh and 20 ºdh you may choose either 4 or 5 programs with the recommended nilfi sk alto deter gents though for best cleaning result we recommend to install the water softening option when choosing 5 programs 17
- If you choose to run with 4 program steps we recommend that you exchange the active wax detergent with the auto dry in program 4 program step 5 should not be used use the extra stop sticker in the plastic bag with coin labels to blank program 5 on the front label deactivate program 5 by setting switch s11 in off position 17
- Original instructions 17
- Program description flow rate temp detergent water memo 17
- Programs and program selector 17
- Programs with water softener soft water 17
- Programs without water softener hard water 17
- When payment in done the user can choose freely between the auto booster s wash ing programs within the time paid for 17
- With soft water 10 ºdh we recommend that you use 5 programs with the recommended nilfi sk alto detergents 17
- ºdh you must install a water softening unit 11 17
- Auto booster 18
- Auto booster 19
- Detergents a and b 19
- Nilfi sk alto s suggestions for detergent addition per program step 19
- Original instructions 19
- Prior to setting the auto booster into operation the entire ma chine should be properly vented section 3 and the settings of the paying system should be carried out section 4 to 4 19
- Program description flow rate temp detergent water 19
- Programs water hardness 10 dh or water softener installed 19
- Running the auto booster 4 starting up 19
- The concentration of detergent can be adjusted on the indi vidual detergent pumps the concentration of detergent in the water jet can be adjusted from 0 0 19
- Turn the main switch on the front of the electric box to position on 2 observe that the display next to the coin input is illuminated and shows 01 00 if minimum value is set to 1 19
- Auto booster 20
- Auto booster 21
- Auto booster 22
- Auto booster 23
- Auto booster 24
- Maintenance 24
- Auto booster 25
- Auto booster 26
- Auto booster 27
- Auto booster 28
- Trouble shooting 28
- Auto booster 29
- Applying to machines with the optional water softening equipment sound pressure level 30
- Auto booster 30
- Diesel according to en 590 up to 7 bio diesel can be used with the following restrictions maximum storage time in high pressure cleaner diesel tank 1 month diesel stored externally for more than 6 months is not allowed to be filled into nilfisk alto high pres sure cleaners diesel en 590 is not recommended for use in hpw s at an ambient temperature below 0 c diesel en 590 from an open container must not be used 30
- Measured in accordance with iso 11202 distance 1m full load 69 db a we reserve the right to make alterations 30
- Original instructions 30
- Technical data 30
- Auto booster 31
- Declaration of conformity 31
- Warranty 31
- Dc input 32
- Mitsubishi 32
- Head quarter 33
- Sales companies 33
Похожие устройства
- Nilfisk SH SOLAR D Информационный бюллетень
- Nilfisk SH SOLAR D Инструкция по эксплуатации
- Arte Lamp Twist A7603AP-1BK Инструкция по сборке
- Nilfisk SH SOLAR E Информационный бюллетень
- Nilfisk SH SOLAR E Инструкция по эксплуатации
- Arte Lamp Twist A7603AP-1WH Инструкция по сборке
- Dometic TEC 40D Инструкция по монтажу
- Dometic TEC 40D Инструкция по эксплуатации
- Nilfisk SH SOLAR G Информационный бюллетень
- Nilfisk SH SOLAR G Инструкция по эксплуатации
- Nilfisk SH TRUCK Информационный бюллетень
- Nilfisk SH TRUCK Инструкция по эксплуатации
- Arte Lamp Spillo A1116LT-1BK Инструкция по сборке
- Arte Lamp Spillo A1116LT-1WH Инструкция по сборке
- Arte Lamp Waverley A8880AP-1BK Инструкция по сборке
- Arte Lamp Hall A9248AP-1AB Инструкция по сборке
- Dometic CoolAir SP-FF для RENAULT T+C Руководство по монтажу
- Dometic CoolAir SP-FF для MB ACTROS SFTP Инструкция по монтажу
- Dometic CoolAir SP-FF для Volvo FH4 (Euro 6) Руководство по монтажу
- Dometic CoolAir SP-FF для моделей MAN TGS/TGX L, LX, XL Руководство по монтажу