Laserliner Quadrum DigiPlus 410 S 053.300A [15/244] Quadrum digiplus quadrum digiplus green

Quadrum DigiPlus / Quadrum DigiPlus Green

–

Quadrum DigiPlus Green: green laser technology

The distance at which a laser is visible to the naked eye depends on its colour i.e. wavelength. This is

because of the human eye‘s physiology – green appears brighter to us than red. Depending on ambient

light, green lasers are therefore many times more visible than red lasers; in indoor areas this is as much

as 12 times brighter. This permits applications on dark surfaces, over longer distances and work in very

bright ambient light. A red laser with a 635 nm wavelength is used as a reference value for brightness

differentiation.

In contrast to red lasers, green laser light can only be produced indirectly. This is a source of potential

characteristic fluctuations:

– The optimal operating temperature is 20°C. Outside of its operating temperature range of 0 – 40°C,

the green rotary laser will be darker. IMPORTANT: Allow the unit enough time to adapt to the

ambient temperature before switching the unit on.

– Laser brightness may vary somewhat from one unit to another. This is a natural phenomena and

excluded from warranty claims.

– Green Laser will only work with certain Receivers. The maximum range of the Receiver is shorter,

please refer to technical details.

Battery charging

– Charge the device‘s battery completely prior to use.

– Connect the charger to mains power supply and the charging

socket (J) of the battery compartment (L). Please only use the

charger supplied; using a different charger will invalidate the

warranty. The rechargeable battery can also be charged when

it is not inserted in the device.

– When the rechargeable battery is being charged, the LED on

the charger (N) lights up red. When the LED changes to green,

charging is complete. When the unit is not connected to the

charger the power charger‘s LED lamp will blink.

– Alkaline batteries (4 x type C) can be used as an alternative.

Insert them in the battery compartment (K) as per the

installation symbols.

– Insert battery (L) / battery compartment (K) into slot (G) and

secure it in place with fastening screw (I). The electrical

contacts (H) must be connected.

– With the rechargeable battery inserted, the device is ready

to run even during charging.

– If the battery symbol (14) flashes continuously on the LC display,

the batteries must be replaced or the rechargeable battery must

be charged.

Insert batteries into the remote control

– Observing the correct polarity.

Quadrum_DigiPlus_Rev0112.indd 15 13.02.12 12:02