Jungheinrich ERC 214 [179/214] Õungheinrich event messages

õUNGHEINRICH Event Messages

03.15179

_7591Operation

UPC specific:

The job could not be

completed

Order runtime in controller exceeded

-Manually reverse the shuttle, start the job again

-Check sensors for contamination, incorrect

settings and faults

-Check pallet

-Check rail holes for contamination

-Test drive system (manual travel)

-If the shuttle remains near a rail hole, you may

need to adjust the pallet distance parameters or

the channel end distance parameters slightly.

_7601Operation

UPC specific:

Pallet lift error at start

Incorrect signal constellation at sensors 7B37.1 - 7B37.4

No signals from incremental transmitter 1B5

-Repeat travel job

-Position pallet correctly at first pallet location

-Check pallet

-Check pallet detection sensors 7B37.1-7B37.4

for contamination, incorrect settings and faults

-Check incremental transmitter 1B5

-Check wire connection

-Check drive chain

_7602Operation

UPC specific:

Pallet lift error

Incorrect signal constellation at sensors 7B37.1 - 7B37.4

-Manually reverse shuttle

-Repeat travel job

-Check pallet

-Check pallet detection sensors 7B37.1-7B37.4

for contamination, incorrect settings and faults

-Check wire connection.

_7611Operation

UPC specific:

Obstacle detection

Negative signal at sensors 7B34.1 - 7B34.4

-Manually reverse shuttle while checking for

possible obstacles in the way of the shuttle

-Check obstacle sensors 7B34.1 - 7B34.4 for

contamination, incorrect settings and faults

-Check wire connection

-Check channel for obstacles (load, wooden

remains and shrink wrap)

-Check channel for possible reflection causes

F E XX SOperational

Status

DescriptionCause / Triggering EventAction

Jungheinrich ERC 214 [179/214] Õungheinrich event messages

Содержание

Похожие устройства