Jungheinrich ERC 214 [172/214] Õungheinrich event messages
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Jungheinrich ERC 214 [172/214] Õungheinrich event messages

Jungheinrich ERC 214 [172/214] Õungheinrich event messages
õUNGHEINRICH Event Messages
03.15172
G
_70526Operation
The maximum permitted
speed for the steering angle
has been exceeded.
The maximum permitted speed for the steering angle
has been exceeded, e.g. due to the steering angle being
changed too quickly.
-Verification of the actuation by the higher-order
system (layout)
_70530
The sideshifter moves
despite power-up test error
Monitoring module: Despite a power-up test error a
speed > 10 mm/s is detected
-Check truck controller cut-out function;
_70531
The sideshifter moves
despite an overspeed error
Monitoring module: Despite a stop a speed > 10 mm/s is
detected
-Check truck controller cut-out function;
_70534Operation
Sideshift or tilt inching speed
exceeded despite reduction
to inching speed
Monitoring module: during an active speed reduction to
inching speed an excessive sideshift or tilt speed is
detected
-Switch the truck off and on again;
-Check lift height sensor system;
-Check load weight sensor system;
-Inquire about software update;
-Replace signal-issuing controller;
_70540
The rotary drive moves
despite power-up test error
Monitoring module: Despite a power-up test error a
speed > 5 °/s is detected
-Check truck controller cut-out function;
_70541
The rotary drive moves
despite an overspeed error
Monitoring module: Despite a stop a speed > 5 °/s is
detected
-Check truck controller cut-out function;
_70544
Rotate inching speed
exceeded despite reduction
to inching speed
Monitoring module: during an active speed reduction to
inching speed a rotate speed > V_INCH is detected
-Check the inching speed setting against the
data sheet values;
-Check the brake ramp settings;
_70550Operation
Drive slave should be
switched on, but it is
disabled
The event message is triggered
if for T > 250 ms the following applies:
•The master has switched on a slave, but the slave
reports the "Off" status
-Read logbook:
-Send logbook to Technical Support;
_7061Operation
Emergency stop through
safety computer
Emergency stop during operation through safety
computer (response to EMCY emergency stop)
-If this error occurs permanently contact
Technical Support;
_7071Operation
Prevent accidental start-up
from stationary position
No setpoint available from accelerator pedal (travel
setpoint), the speed-evaluating inputs detect a changing
actual speed.
-Check traction motor speed sensors, replace if
necessary.
F E XX SOperational
Status
DescriptionCause / Triggering EventAction

Содержание

Похожие устройства

Скачать