Zyxel IES-1000 EE [100/368] Alarm port setup screen

Chapter 16 Alarm

VOP1224-61 User’s Guide

100

16.5 Alarm Port Setup Screen

Use this screen to set the alarm severity threshold for recording alarms on an

individual port(s). The system reports an alarm on a port if the alarm has a

severity equal to or higher than the port’s threshold.

To open this screen, click Alarm > Alarm Port Setup.

Figure 40 Alarm Port Setup

Syslog Select this check box to have the system send this alarm to a syslog

server.

Severity Select an alarm severity level (critical, major, minor or info) for

this alarm. Critical alarms are the most severe, major alarms are the

second most severe, minor alarms are the third most severe and info

alarms are the least severe.

Clearable Select this check box to allow administrators to use the management

interface to remove an alarm report generated by this alarm event

entry.

Select this check box to keep an alarm report generated by this alarm

event in the system until the conditions that caused the alarm report

are no longer present.

Apply Click Apply to save your changes to the VOP’s volatile memory. The

VOP loses these changes if it is turned off or loses power, so use the

Config Save link on the navigation panel to save your changes to the

non-volatile memory when you are done configuring.

Close Click Close to exit the screen without saving your changes.

Table 30 Alarm Event Setup Edit (continued)

LABEL DESCRIPTION