Zyxel IES-1000 EE [243/368] Uploading the default configuration file

Chapter 32 Troubleshooting

VOP1224-61 User’s Guide

243

4 Type y at the question “Do you want to restore default ROM file(y/n)?”

5 The VOP restarts.

The VOP is now reinitialized with a default configuration file including the default

user name of “admin” and the default password of “1234”.

32.9.2 Uploading the Default Configuration File

If you forget your password or cannot access the VOP, you will need to reload the

factory-default configuration file. Uploading the factory-default configuration file

replaces the current configuration file with the factory-default configuration file.

This means that you will lose all previous configurations and the speed of the

console port will be reset to the default of 9600bps with 8 data bit, no parity, one

stop bit and flow control set to none. The password will also be reset to “1234”

and the IP address to 192.168.1.1.

Note: Uploading the factory default configuration file erases the VOP’s entire

configuration.

Obtain the default configuration file, unzip it and save it in a folder. Use a console

cable to connect a computer with terminal emulation software to the VOP’s

console port. Turn the VOP off and then on to begin a session. When you turn on

the VOP again you will see the initial screen. When you see the message Press

any key to enter Debug Mode within 3 seconds press any key to enter debug

mode.

To upload the configuration file, do the following:

1 Type atlc after the Enter Debug Mode message.

2 Wait for the Starting XMODEM upload message before activating XMODEM upload

on your terminal.

Figure 85 Resetting the Switch Via Command

ras> config restore

System will reboot automatically after restoring default configuration.

Do you want to proceed(y/n)? >

restoring configuration...

saving configuration to flash...