Home
Главная
D-Link
Коммутатор
DGS-1210-52/ME rev.A
Руководство пользователя _CLI_ Страница: 162

D-Link DGS-1210-52/ME rev.A [162/457] Create syslog host

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide

144

Syslog Global State: Enabled

DGS-1210-28P/ME:5#

create syslog host

Purpose

To create a new syslog host.

Syntax

create syslog host <index 1-4> ipaddress [<ipaddr> |

<ipv6addr>] {severity [informational | warning | all] | facility

state [enable | disable] | udp_port [514 | <udp_port_number

6000-65535>]}

Description

The create syslog host command creates a new syslog host.

Parameters

all − Specifies that the command is to be applied to all hosts.

<index 1-4> − The syslog host index id. There are four available

indices, numbered 1 to 4.

ipaddress [<ipaddr> | <ipv6addr>] − The IPv4 or IPv6 address of the

remote host to which syslog messages are to be sent.

severity − The message severity level indicator. These are

DGScribed in the table below (Bold font indicates that the

corresponding severity level is currently supported on the Switch):

Numerical Severity

Code

0 Emergency: system is unusable

1 Alert: action must be taken immediately

2 Critical: critical conditions

3 Error: error conditions

4 Warning: warning conditions

5 Notice: normal but significant condition

6 Informational: informational messages

7 Debug: debug-level messages

informational − Specifies that informational messages are to be sent

to the remote host. This corresponds to number 6 from the list

above.

warning − Specifies that warning messages are to be sent to the

remote host. This corresponds to number 4 from the list above.

all − Specifies that all message are to be sent to the remote host.

facility − Some of the operating system daemons and processes

have been assigned Facility values. Processes and daemons that

have not been explicitly assigned a Facility may use any of the ‘local

use’ facilities or they may use the ‘user-level’ Facility. Those

Facilities that have been DGSignated are shown in the table below

(Bold font indicates the facility values that the Switch currently

supports):

Numerical Facility

Code

D-Link DGS-1210-52/ME rev.A [162/457] Create syslog host

Содержание

Похожие устройства