Qtech QSW-8200-28T-AC-DC [18/74] Set originator id

User Manual

Chapter 1. Commands for Routing Policy 18

www.qtech.ru

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)#set origin egp

1.26 set originator-id

 Command: set originator-id <ip_addr>

 no set originator-id [<ip_addr>]

 Function: Configure the origin ip address of the BGP routing message. The “no set

originator-id [<ip_addr>]” command deletes the configuration.

 Parameter: <ip_addr> is the ip address of the route source shown by dotted decimal

notation.

 Command Mode: route-map mode

 Usage Guide: To use this command, one match clause should at first be defined.

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)#set originator-id 10.1.1.1

1.27 set tag

 Command: set tag <tag_val>

 no set tag [<tag_val>]

 Function: Configure the tag domain of OSPF routing messages. The “no set tag

[<tag_val>]” command deletes this configuration.

 Parameter: <tag-val > is the tag value, ranging between 0～4294967295.

 Command Mode: route-map mode

 Usage Guide: There is a route-tag domain at the AS-external-LSA type LSA. The domain

is normally identified by other routing protocols. To use this command, one match

clause should at first be defined.

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)#set tag 60

1.28 set vpnv4 next-hop

 This command is not supported by the switch.