Qtech QSW-8200-28T-AC-DC [55/74] Offset list

User Manual

Chapter 4. Commands for RIPng 55

www.qtech.ru

 Example: Switch#config terminal

 Switch(config)#router ipv6 rip

 Switch(config-router)#neighbor FE80:506::2 Vlan1

 Related Command: passive-interface

4.13 offset-list

 Command: offset-list <access-list-number|access-list-name> {in|out}

<number >[<ifname>|vlan <vlan-id>]

 no offset-list <access-list-number|access-list-name> {in|out }<number >[<ifname>|vlan

<vlan-id>]

 Function: Add an offset value on the routing metric value learnt by RIPng. The “no

offset-list <access-list-number|access-list-name> {in|out} <number >[<ifname>|vlan

<vlan-id>]” command disables this function.

 Parameter: <access-list-number |access-list-name> is the access-list or name to be

applied. <number> is the additional offset value, ranging between 0-16; <ifname> is the

name of specific interface.

 Default: The default offset value is the metric value of the interface defined by the

system.

 Command Mode: Router mode

 Example: Switch#config terminal

 Switch(config)#router ipv6 rip

 Switch(config-router)#offset-list 1 in 5 Vlan1

 Related Command: access-list

4.14 passive-interface

 Command: passive-interface<ifname>|vlan <vlan-id>

 no passive-interface<ifname>|vlan <vlan-id>

 Function: Set the RIPng layers 3 switches to block RIPng broadcast on the specified

interfaces, and only send the RIPng data packet to the layer 3 switch which is configured

with neighbor.

 Parameter: <ifname> is the specific interface name.

 Default: Not configured

 Command Mode: Router mode

 Example: Switch#config terminal