Qtech QSW-8200-28T-AC-DC [71/74] Ip route bfd

User Manual

Chapter 6. Commands for BFD 71

www.qtech.ru

6.13 ip route bfd

 Command: ip route {vrf <name> <ipv4-address> | <ipv4-address>} mask <nexthop> bfd

 no ip route {vrf <name> <ipv4-address> | <ipv4-address>} mask <nexthop> bfd

 Function: Configure BFD for the static route, no command cancels the configuration.

 Parameter: <name> is vrf name, <ipv4-address> is destination address, mask is the

subnet mask, nexthop is nexthop address

 Command Mode: Global mode

 Default: BFD is not configured for the static route.

 Usage Guide: Configure BFD for the route and specify the detection mode.

 Example: Configure BFD for the static route.

 s3(config)#ip route 10.1.1.0/24 20.1.1.2 bfd

6.14 ipv6 ospf bfd enable

 Command: ipv6 ospf bfd enable

 no ipv6 ospf bfd enable

 Function: Configure BFD for OSPFv3 protocol on the specific interface, no command

cancels the configuration.

 Parameter: None.

 Default: BFD is no enabled for OSPFv3.

 Command Mode: Interface configuration mode

 Usage Guide: Configure BFD for OSPFv3 protocol enabled by the specific interface, BFD

will inform OSPFv3 after detect link fault and OSPFv3 will deal with it in best times.

 Example: Enable BFD for OSPFv3 on interface.

 s5(config-if-vlan50)#ipv ospf bfd enable

6.15 ipv6 ospf bfd enable instance-id

 Command: ipv6 ospf bfd enable instance-id <0-255>

 no ipv6 ospf bfd enable

 Function: Configure BFD for OSPFv3 instance on the specific interface, no command

cancels the configuration.

 Parameter: None.

 Default: BFD is no enabled for OSPFv3 instance.

 Command Mode: Interface configuration mode