Qtech QSW-8200-28T-AC-DC [53/74] Ipv6 rip split horizon

User Manual

Chapter 4. Commands for RIPng 53

www.qtech.ru

routing information for RIPng. The no form of this command will disable the debugging

switch.

 Parameter: None.

 Default: Close the debug by default.

 Command Mode: Admin Mode.

 Usage Guide: None.

 Example:

 Switch#debug ipv6 rip redistribute route receive

 Switch# no debug ipv6 rip redistribute route receive

4.9 ipv6 rip aggregate-address

 Command: ipv6 rip aggregate-address X:X::X:X/M

 no ipv6 rip aggregate-address X:X::X:X/M

 Function: To configure IPv6 aggregation route. The no form of this command deletes

the IPv6 aggregation route.

 Parameter: X:X::X:X/M: IPv6 address and prefix length.

 Command Mode: Router Mode or Interface Configuration Mode.

 Default: No aggregation route configured.

 Usage Guide: If to configure aggregation route under router mode, RIPng protocol must

be enabled. If configured under interface configuration mode, RIPng protocol may not

be enabled, but the aggregation route can operation after the RIPng protocol be

enabled on interface.

 Example: To configure aggregation route as 2001:3f:ed8::99/64 globally.

 Switch(config)#router rip

 Switch(config-router) #ipv6 rip agg 2001:3f:ed8::99/64

4.10 ipv6 rip split-horizon

 Command: ipv6 rip split-horizon [poisoned]

 no ipv6 rip split-horizon

 Function: Permit the split horizon. The “no ipv6 rip split-horizon” disables the split

horizon.

 Parameter: [poisoned] configures split horizon with poison reverse.

 Default: Split horizon with poison reverse.

 Command Mode: Interface Configuration Mode.