Qtech QSW-8200-28T-AC-DC [58/74] Show debugging ipv6 rip

User Manual

Chapter 4. Commands for RIPng 58

www.qtech.ru

4.19 show debugging ipv6 rip

 Command: show debugging ipv6 rip

 Function: Show RIPng debugging status for following debugging options: nsm

debugging, RIPng event debugging, RIPng packet debugging and RIPng nsm debugging.

 Command Mode: Admin mode

 Example:

 Switch#show debugging ipv6 rip

 RIPng debugging status:

 RIPng event debugging is on

 RIPng packet detail debugging is on

 RIPng NSM debugging is on

4.20 show ipv6 rip interface

 Command: show ipv6 rip interface

 Function: Make sure the interface and line protocols is up.

 Command Mode: Admin mode

 Example: Switch(config)#show ipv6 rip interface

 Loopback is up, line protocol is up

 RIPng is not enabled on this interface

 Vlan1 is up, line protocol is up

 Routing Protocol: RIPng

 Passive interface: Disabled

 Split horizon: Enabled with Poisoned Reversed

 IPv6 interface address:

 3000:1:1::1/64

 fe80::203:fff:fe0c:cda/64

Displayed information

Explanations

Vlan1 is up, line protocol is up

Interface is Up

Routing Protocol: RIP

The routing protocol running on the

interface is RIPng

Passive interface: Disabled

Passive-interface disabled