Qtech QSW-8200-28T-AC-DC [48/74] Version

User Manual

Chapter 3. Commands for RIP 48

www.qtech.ru

timers basic” command restores each parameter to their default values.

 Parameter: <update> time interval of sending update packet, shown in seconds and

ranging between 5-2147483647; <invalid> time period after which the RIP route is

advertised dead, shown in seconds and ranging between 5-2147483647; <garbage> is

the hold time in which the a route remains in the routing table after advertised dead,

shown in seconds and ranging between 5-2147483647.

 Default: <update> defaulted at 30; <invalid> defaulted at 180; <garbage> defaulted at

120

 Command Mode: Router mode

 Usage Guide: The system is defaulted broadcasting RIPng update packets every 30

seconds; and the route is considered invalid after 180 seconds but still exists for another

120 seconds before it is deleted from the routing table.

 Example: Set the RIP update time to 20 seconds and the timeout period to 80 second,

the garbage collecting time to 60 seconds.

 Switch(Config-Router)#timers basic 20 80 60

3.47 version

 Command: version {1| 2}

 no version

 Function: Configure the version of all RIP data packets sent/received by router

interfaces: the “no version” restores the default configuration.

 Parameter: 1 is version 1 rip; 2 is version 2 rip.

 Default: Sent and received data packet is version 2 by default.

 Command Mode: Router mode and address-family mode

 Usage Guide: 1 refers to that each interface of the layer 3 switch only sends/receives

the RIP-I data packets. 2 refers to that each interface of the layer 3 switch only

sends/receives the RIP-II data packets. The RIP-II data packet is the default version.

 Example: Configure the version of all RIP data packets sent/received by router

interfaces to version 2.

 Switch(config-router)#version 2

 Related Command: ip rip receive version

 ip rip send version