Qtech QSW-8200-28T-AC-DC [57/74] Router ipv6 rip

User Manual

Chapter 4. Commands for RIPng 57

www.qtech.ru

 Default: Not redistributed by default.

 Command Mode: RIPng Configuration Mode.

 Usage Guide: None.

 Example: To redistribute OSPFv3 ABC routing ro RIPng.

 Switch(config)#router ipv6 rip

 Switch (config-router)#redistribute ospf abc

4.17 route

 Command: route <ipv6-address>

 no route <ipv6-address>

 Function: This command configures a static RIPng route. The “no route <ipv6-address>”

command deletes this route.

 Parameter: Specifies this destination IPv6 address prefix and its length show in colon

hex notation.

 Usage Guide: The command adds a static RIPng route, and is mainly used for

debugging. Routes configured by this command will not appear in kernel route table but

in the RIPng route database, however it could be located by using the show ipv6 rip

command.

 Command Mode: Router mode

 Example: Switch#config terminal

 Switch(config)#router ipv6 rip

 Switch(config-router)#route 3ffe:1234:5678::1/64

4.18 router ipv6 rip

 Command: router ipv6 rip

 no router ipv6 rip

 Function: Enable RIPng routing process and entering RIPng mode; the “no router ipv6

rip” of this command disables the RIPng routing protocol.

 Default: RIPng routing not running.

 Command Mode: Global mode

 Usage Guide: This command is for enabling the RIPng routing protocol, this command

should be enabled before performing other global configuration of the RIPng protocol.

 Example: Enable the RIPng protocol mode.

 Switch(config)#router ipv6 rip