DJI Inspire 1 Remote Controller [26/63] Upgrading firmware of aircraft

2.10 Upgrading Firmware of Aircraft

Upgrade the firmware of the aircraft thought the camera’s SD card.

2.11 Attaching and Detaching the Propellers

Use only DJI-made propellers with your Inspire 1. The gray or black nut on the propeller indicates the rotation direction

of the propeller and where it should be attached. To attach the propeller properly, match the nut with the dots on the

motors of your Inspire 1:

Propellers

Grey cap（1345）

Black cap（1345R）

Figure

Attach On

Motors without a black dot

Motors with a black dot

Legends

Lock：Turn the propellers in the indicated direction to mount and tighten

Unlock：Turn the propellers in the indicated direction to loosen and remove

Attaching the Propellers

1. Read the instruction cards located on each of the four motors and remove them from the motor.

2. Attach the propellers with a gray nut onto a motor without a black dot and spin the propellers clockwise to

secure them in place.

Attach the propellers with a black nut onto a motor with a black dot and spin the propellers counter clockwise

to secure its position.

Figure 18 Figure 19

Propelller is designed as slef tighen. DO NOT use thread locker to secure its position.

(1) Ensure propellers are attached to its corresponding motors, otherwise the aircraft

cannot take off.

(2) Wear glove when handling propellers.

Detaching the Propellers

Use included wrench to hold the motor still. Then spin the propeller in the unlock direction indicated on the propeller

itself.