Airrobo T10+ [13/87] Part 5 troubleshooting

- 11 -

Part 5 Troubleshooting

10. Reboot

If buttons do not respond or cannot be shut down, please press and hold the reset button with a needle inserted for 1 second, and the

robot will be powered off and rebooted.

The power light flashes red quickly when the robot is not working properly. It will also play a voice prompt when a fault occurs. Please

refer to the instruction sheet below.

Voice prompt/Problem description Possible Causes Solution

Please check if the radar is stuck. The laser radar is blocked or stuck.

robot to an open area and restart it.

Please wipe the cliff sensor and stay

away from the dangerous area before

starting the robot.

Wipe the cliff sensor, move the robot to an open

area and restart it.

Please check the main brush. The main brush is stuck.

The side brush is stuck.

The main wheel is stuck.

The 2-in-1 watertank is not in place.

temperature.

1. The base is not powered on.

2. Charging contacts and dust collection

induction are dirty.

3. Poor contact of the charging contacts.

The base is blocked, or the distance

is too far.

Program error.

Main brush/side brush or main wheel

entangled with foreign objects.

Please wipe the ToF wall sensor.

Radar's upper cover is being pressed.

The radar is pressed down or stuck. Please move it

to an open area and restart it.

The battery is damaged or not

installed.

Battery temperature is too high or too low, please

wait 30 minutes before cleaning.

Cannot be powered on.

Battery runs low, charge it before use. Besides, do

the cleaning at 0~40°C temperature.

Cannot charge.

or other foreign objects.

Failed to charge, cannot find the base.

Take out the 2-in-1 watertank.

Reinstall the 2-in-1 watertank and filter, confirm

they are in place.

Settle the base in an open area, then place the

robot nearby and try again.

Irregular behavior.

Press the Reset button to restart after it is powered

off.