Airrobo T10+ [14/87] Part 6 basic parameters

- 12 -

Part 6 Basic parameters

When the base occurs a problem, the three icons on the LCD screen will be on at the same time. Please refer to the following instruction.

Voice prompt/Problem descr Possible Causes Solution

Decreased cleaning ability or spilled

dust & dirt.

The dustbin is full, or the filter is

blocked, or the main brush is entangled.

Clean the dustbin, filter, and main brush regularly.

Make sure the robot cleaning in an area with good

Wi-Fi signal. Make sure the Wi-Fi password is correct.

Or try to restart the router and update the APP.

No or little water when mopping.

The water tank is short of water, or the

mop is dirty, or the mopping module is

not installed properly.

Check whether there is water in the water tank, clean

the mop, and install the mop correctly according to

the instructions. Only clean water is allowed to be

added in the water tank. Check whether the water

outlet is blocked by foreign objects.

Too much water when mopping.

cleaning cannot start even after the

battery is fully charged.

The robot is in the Do Not Disturb mode.

In DND mode or manually putting the robot back to

the base instead of letting it go back automatically

when returning, it will not resume cleaning.

Cannot return to the base after

cleaning.

The base has been moved to another

room after starting the cleaning.

It is recommended to start cleaning from the base and

do not move the base after the cleaning starts.

Install the disposable dust bag and try to clean the

dust again after 30 minutes.

Dust bag is full or blocked.

The disposable dust bag is full or

blocked.

Replace the disposable dust bag, clean the dust

suction port, dust passage, fan filter of the base

regularly.

Model L2550-J

349×100×353 mm

Input

Working voltage

Battery capacity

Wireless connections

Robot vacuum cleaner