CLAVIA DMI AB CLAVIA NORD Stage 2 EX Compact [63/101] Morph assignable parameters

Nord Stage EX v6.x 9. The Morph Assign feature: Morph Assignable parameters

Page 61

5. Hold down the WHEEL button in the Morph Assign section again while turning the Instrument

EVEL knob that was set to minimum value in Step 2 up to maximum value.

6. Release the W

HEEL button in the Morph Assign section.

7. When you now move the Wheel, the Level is gradually lowered for one instrument and raised for

the other instrument, allowing you to “morph” between the two instruments!

If you double-click a Morph button (W

HEEL, A.TOUCH or CTRLPEDAL), it will stay active, and you

can assign any number of morphs without holding the Morph button. When you have finished assign-

ing Morph parameters, press E

XIT (SHIFT) to exit. This for example allows for one-handed Morph

assignments.

MORPH ASSIGNABLE PARAMETERS

Basically you can use the Morph function to control all rotary encoders (knobs that show parameter

values with LEDs) and the organ drawbars. Apart from the number of assignable parameters, there is

no limit to how many parameters you can control simultaneously using Morph.

The following parameters can be Morph controlled:

• The L

EVEL knobs for all Instrument sections.

• The T

IMBRE knob in the Synth section.

• The F

ILTER FREQUENCY knob in the Synth section.

• The D

RAWBARS in the Organ section.

• The Effect R

ATE/TEMPO knob.

• The Effect A

MOUNT knob.

• The P

ARAMETER knob in the Extern section (see page 64).

• The R

OTOR SPEED button. E.g. hold down the WHEEL button in the Morph Assign section, and

press the R

OTOR SPEED button once. Now the Wheel controls the Rotor Speed, which is indicated

by clearly lit R

OTOR SPEED LEDs when the corresponding Morph button is held. Note that this

enables you to set Rotor Speed continuously, instead of just alternating between two fixed speeds.

To deactivate, hold down the W

HEEL button in the Morph Assign section, and press the ROTOR

PEED button again.