D-Link DWS-3024 [204/266] Default d link access point settings

D-Link Unified Access System Software User Manual

02/15/2011

Page 204 Document 34CS3000-SWUM104-D10

DEFAULT D-LINK ACCESS POINT SETTINGS

Table 86 shows the default D-Link Access Point settings. The settings are the same for DWL-3500AP, DWL-8500AP, and

DWL-8600AP.

DEFAULT D-LINK ACCESS POINT PROFILE SETTINGS

Table 87 shows the AP settings for the default profile. By default, when a D-Link Access Point associates with the switch,

the settings in this table are assigned to the AP upon successful AP validation.

Table 86: Default AP Settings

Feature Default

System Information

User Name admin

Password admin

Network Information

DHCP Client Enabled

Management IP Address 10.90.90.91 (If not assigned by DHCP)

Subnet Mask 255.0.0.0 (If not assigned by DHCP)

Management VLAN 1

Untagged VLAN 1

Note: Only the settings for Radio 2 will be applied to DWL-3500APs if they are managed by a DWS-3000 switch.

Table 87: AP Profile Default Settings

Feature Default

Radio Settings

Radio (1 and 2) State On

Radio 1 IEEE 802.11 Mode 802.11a

Note: If the AP operates in a regulatory domain where 802.11a is

not supported, the radio is disabled and no mode is configured.

Radio 2 IEEE 802.11 Mode 802.11b/g

Super AG Disabled

RTS Threshold 2347 bytes

Load Balancing Disabled

Load Utilization 60%

RF Scan Other Channels Disabled

RF Scan Interval 60 seconds

RF Scan Sentry Disabled

Station Isolation Disabled