AXIOMET AX-EL300W60A [10/72] Functions and features

6) Sequence (List) Operation:

The LCD shows actual voltage, current, power and time. The second line shows set level and sequence

operation mode.

7) Battery Discharge Operation:

The first line shows actual voltage, current, battery capacity and discharge time.

8) Short Circuit Operation:

The LCD shows actual voltage, current, power and resistance levels. The second line shows set level in

short circuit mode. Please refer to Main Specifications for details.

9) Protection Status

If the protection function is active, the indicator of “Cancel” is turned on, LCD will display corresponding

protection status. For example: the display of reverse voltage protection status is shown as below: Pro-

tection status includes overcurrent (OC), overvoltage (OV), overpower (OP), overtemperature (OT), load

protection (PT), and reverse voltage (RV).

10) Input On/Off

When the indicator of “On/Off” is turned on, the load’s input is in On status; on the contrary, the load’s

input is in Off status.

2.9. Remote Programming

The commands are sent to electronic load via remote interface (RS232), and will be executed after decoding

by the processor. If there is any error occurs to the command, the processor can detect the wrong command

and error type, and it can maintain the status register as well.

When the instrument address is set between 32 and 255, the address value should be added at the haad

of commands. When the instrument address is set higher than 256, the address become invalid, and the

address value does not need to be added at the head of commands.

3. Functions and Features

3.0.

The functions and features of electronic load will be described in this chapter, which helps you to know this

series better.

3.1. Local and Remote Control

This series electronic load can be controlled via the front panel, or by remote controller via remote interface.

If it is needed to control the load via the front panel, the load has to stay in local control status. Local (front

panel) control is in effect immediately after power is applied. Remote control goes into effect as soon as the

load receives a SYSTem:REMote command via RS232.