AXIOMET AX-EL300W60A Расширенная инструкция онлайн [56/72] 527990

5 /// Press “Cancel” key to exit the main menu. ///

6 /// Press “V-set” key to select CVL mode, press “Enter” key to confirm and exit the mode selection and

parameter setting menu. ///

7 /// Press “On/Off” key to turn on the load. ///

For the above operating procedures, the corresponding SCPI commands should be:

INPUT:SHORT ON ; Sets the load to short circuit

MODE CVL ; Sets the mode

INPUT ON ; Turns on the load

5.13.3. Von Point/Von Latch

Example: Set the Von Latch to Off; set Von Point to 1V; turn on the load; This example implements the

automatic on/off of the load’s input, which simplifies the test operations greatly. The detailed operations

are shown as below:

Procedures /// Operation Descriptions /// Display

1 /// Press “Menu” key to enter into the selectable menu. /// MENU 0 SYST

2 /// Use Entry keys or the knob to select “0 System Set”, press “Enter” key to confirm and enter into System

Set. /// CC SET 0 LOW

3 /// Use “↑”, “↓”keys to select the menu item “Von Latch”. Use the knob to select the parameter “Off”, and

press “Enter” key to confirm. /// VON LA 0 Off

4 /// Use “↑”, “↓”keys to select the menu item “Von Point”. Use Entry keys or the knob together with “ ”,

“ ” keys to input the voltage value to 1V, and press “Enter” key to confirm. /// VON PO 01 .000V

5 /// Press “Cancel” key to exit the main menu. ///

6 /// Press “On/Off” key to turn on the load. ///

For the above operating procedures, the corresponding SCPI commands should be:

INP:VOLT:ON:LATCH OFF ; Disables the Von Latch

INP:VOLT:ON 1 ; Sets the Von voltage point to 1V

INPUT ON ; Turns on the load

5.13.4. Current Limit in CV Mode

Example: Set the load to CVL mode; set the voltage value to 2V; set the current limit value in CV mode

(CV Curr Limit) to 20A; turn on the load. The detailed operations are shown as below:

Procedures /// Operation Descriptions /// Display

1 /// Set the mode to CVL, set the voltage value to 2V (please refer to 4.5.2 section for detailed operations).

///

2 /// Press “Menu” key to enter into the selectable menu. /// MENU 0 SYST

3 /// Use Entry keys or the knob to select “0 System Set”, press “Enter” key to confirm and enter into System

Set. /// CC SET 0 LOW

4 /// Use “↑”, “↓”keys to select the menu item “CV Curr L”. /// CV CUR 120.000A

5 /// Use Entry keys or the knob together with “ ”, “ ” keys to input the current value to 20.000A, and press