![BMW R1150R ABS (2001) [43/95] Replacing brake pads rear brake](/img/pdf.png)
BMW R1150R ABS (2001) [43/95] Replacing brake pads rear brake
![BMW R1150R ABS (2001) [43/95] Replacing brake pads rear brake](/views2/1121014/page43/bg2b.png)
00.38
34 21 200 Replacing brake pads, rear
brake
•
Remove keeper (arrow) from retaining pin.
•
Drive the retaining pin out towards the wheel
side.
•
Remove brake caliper.
•
Remove brake pads.
e Important:
[Integral ABS] Press back pistons in brake caliper
brake pad just far enough to allow the brake disc to
be slipped in.
The fluid in the wheel circuit reservoir must not rise
above “MAX”.
Risk of fluid loss.
If fluid escapes, proceed in accordance with the in-
structions for filling the reservoir.
•
Force back the pistons.
•
Check the springs for correct seating and instal-
lation position.
– The engraved arrow indicates the direction of
travel.
•
Installation is the reverse of the removal proce-
dure.
L Note:
Always wait for the BMW Integral ABS to complete
its self-diagnosis after the ignition is switched on.
Do not operate the brake lever until self-diagnosis is
complete.
•
Perform a function check on the brake system
with the ignition switched on.
X Tightening torque:
Brake caliper to rear wheel drive .................. 40 Nm
R28000160
R22000280
Содержание
- Maintenance bmw integral abs 1
- Bmw annual service 3
- Bmw inspection at 1 000 km 600 miles 3
- Bmw inspection every 20 000 km 12 000 miles 3
- Bmw motorrad maintenance schedule r 1100 s evo r 1150 r r 1150 rt 3
- Bmw service 10 000 km 6 000 miles 3
- Bmw motorrad pre delivery check r 1100 s evo r 1150 r r 1150 rt 4
- Bmw motorrad service data r 1150 r 5
- Item desired value unit of measure ment specification 5
- Brakes 6
- Clutch 6
- Contents 6
- Engine 6
- Engine electrics 6
- Equipment 6
- Exhaust system 6
- Front fork 6
- Fuel preparation and control 6
- Fuel tank and lines 6
- General electrical equipment 6
- Rear wheel drive 6
- Steering 6
- Table of operating fluids 6
- Tightening torque 6
- Tightening torque table of operating fluids 6
- Transmission 6
- Wheels and tyres 6
- Tightening torque 8
- Table of operating fluids 17
- Checking engine oil when engine is cold topping up if necessary 18
- Checking headlight beam angle adjusting if necessary 18
- Checking that delivery is complet 18
- Checking the shipping pallet for damage 18
- Checking tightness of rear wheel studs 18
- Checking tyre pressure 18
- Contents 18
- Filling and charging the batter 18
- Filling and charging the battery 18
- Final cleanin 18
- Final inspection and function check 18
- General view of crated motorcycl 18
- Handing over the motorcycle 18
- In case of damage in german 18
- In case of damage in importer market 18
- Inspecting motorcycle for damag 18
- Installing remaining items on motorcycle 18
- Integral abs performing bleed test with bmw moditec 18
- Mounting the speedster fairin 18
- Pre delivery check 18
- Removing the fuel tan 18
- Unpacking the motorcycl 18
- General view of crated motorcycle 20
- Checking that delivery is complete 21
- Checking the shipping pallet for damage 21
- In case of damage in germany 21
- In case of damage in importer markets 21
- Inspecting motorcycle for dam age 21
- Installing remaining items on motorcycle 21
- Mounting the speedster fair ing 21
- Unpacking the motorcycle 21
- Checking engine oil when engine is cold topping up if neces sary 23
- Checking headlight beam angle adjusting if necessary 24
- Checking tightness of rear wheel studs 24
- Checking tyre pressures 24
- Final cleaning 25
- Final inspection and function check 25
- Integral abs performing bleed test with bmw moditec 25
- Handing over the motorcycle 26
- Changing engine oil replacing oil filter element 28
- Changing the oil in the rear wheel drive 28
- Changing the transmission oil 28
- Checking battery fluid level and topping up if necessary cleaning and greasing the battery terminals 28
- Contents 28
- Front brak 28
- Integral abs checking brake fluid level 28
- Integral abs performing bleed test with bmw modite 28
- Key to maintenance intervals 28
- Maintenance 28
- Reading the bmw moditec fault code memory 28
- Rear brak 28
- Replacing fuel filter 28
- Replacing intake air filter element 28
- Replacing poly v belt 28
- Without integral abs checking brake fluid level 28
- Changing the clutch fluid 29
- Checking brake disc wea 29
- Checking brake pads and discs for wear replacin 29
- Checking brake system for correct operation and freedom from leaks repairing replacing if necessar 29
- Checking clutch operating fluid level 29
- Checking front brake pad wea 29
- Checking rear brake pad wea 29
- Checking tightness of rear wheel studs 29
- Contents 29
- Integral abs bleeding changing brake fluid in front control circui 29
- Integral abs bleeding changing brake fluid in front wheel circui 29
- Integral abs bleeding changing brake fluid in rear control circui 29
- Integral abs changing bleeding brake fluid in control circuit 29
- Integral abs changing bleeding brake fluid in wheel circuit 29
- Replacing brake pads front brak 29
- Replacing brake pads rear brak 29
- Without integral abs bleeding changing brake fluid in front syste 29
- Without integral abs bleeding changing brake fluid in rear syste 29
- Without integral abs changing brake fluid and bleeding the brake system 29
- Checking adjusting valve clearances 30
- Checking function of side stand contact switch 30
- Checking rear wheel bearing play by tilting whee 30
- Checking replacing spark plug 30
- Checking swinging arm bearings adjusting if necessar 30
- Checking throttle cable freedom of movement checking for chafes and kinks replacing if necessary checking throttle cable play checking adjusting idle speed and throttle valve synchronization 30
- Contents 30
- Final inspection with road safety and functional check 30
- Greasing the side stand pivo 30
- Tightening cylinder heads 30
- Integral abs performing bleed test with bmw moditec 32
- Key to maintenance intervals 32
- Reading the bmw moditec fault code memory 32
- Changing engine oil replac ing oil filter element 33
- Changing the oil in the rear wheel drive 34
- Changing the transmission oil 34
- Replacing fuel filter 35
- Replacing poly v belt 38
- Front brake 39
- Min max 39
- Rear brake 39
- Without integral abs checking brake fluid level 39
- Checking brake pads and discs for wear replacing 40
- Checking brake system for correct operation and freedom from leaks repairing replacing if necessary 40
- Checking front brake pad wear 40
- Front brake 40
- Integral abs checking brake fluid level 40
- Rear brake 40
- Checking brake disc wear 41
- Checking rear brake pad wear 41
- Replacing brake pads front brake 42
- Replacing brake pads rear brake 43
- Without integral abs bleeding changing brake fluid in front system 44
- Without integral abs changing brake fluid and bleeding the brake system 44
- Without integral abs bleeding changing brake fluid in rear system 45
- Min max 46
- Integral abs bleeding changing brake fluid in front wheel circuit 47
- Integral abs changing bleeding brake fluid in wheel circuit 47
- Integral abs bleeding changing brake fluid in front wheel circuit 51
- Integral abs bleeding changing brake fluid in front control circuit 55
- Integral abs changing bleeding brake fluid in control cir cuit 55
- Integral abs bleeding changing brake fluid in rear control circuit 57
- Checking clutch operating fluid level 58
- Changing the clutch fluid 59
- Checking function of side stand contact switch 60
- Checking rear wheel bearing play by tilting wheel 60
- Checking replacing spark plugs 60
- Checking swinging arm bearings adjusting if necessary 60
- Checking tightness of rear wheel studs 60
- Greasing the side stand pivot 60
- Checking adjusting valve clearances 61
- Tightening cylinder heads 61
- Checking throttle cable free dom of movement checking for chafes and kinks replacing if nec essary checking throttle cable play checking adjusting idle speed and throttle valve synchronization 62
- Final inspection with road safety and functional check 64
- Assembling rear brake caliper 66
- Bleeding control circuits 66
- Bleeding wheel circuits 66
- Brakes 66
- Checking and adjusting piston rod play 66
- Contents 66
- Disassembling and assembling front brake caliper 66
- Disassembling and assembling rear brake caliper 66
- Dismantling rear brake caliper 66
- Installing the abs pressure modulator 66
- Integral abs draining brake system 66
- Integral abs removing and refitting front abs sensor 66
- Integral abs removing and refitting rear abs sensor 66
- Integral abs removing installing the abs pressure modulator 66
- Removing and refitting brake master cylinder 66
- Removing and refitting brake piston in handlebar fitting 66
- Removing and refitting footbrake lever 66
- Removing and refitting front brake caliper 66
- Removing and refitting front brake discs 66
- Removing and refitting rear brake caliper 66
- Removing and refitting rear brake disc 66
- Removing the abs pressure modulator 66
- Technical dat 66
- Contents 67
- Filling control circuits 67
- Filling wheel circuits 67
- Integral abs filling the brake system 67
- Integral abs performing a bleed test with bmw moditec 67
- Integral abs reading fault code memory with bmw moditec 67
- Integral abs removing installing brake lines 67
- Integral abs removing installing wheel circuit reservoir bleed lines 67
- Removing and refitting front brake line 67
- Removing and refitting rear brake line 67
- Removing installing brake lines 67
- Removing and refitting front brake caliper 69
- Disassembling and assem bling front brake caliper 70
- Removing and refitting rear brake caliper 71
- Assembling rear brake caliper 72
- Disassembling and assembling rear brake caliper 72
- Dismantling rear brake caliper 72
- Removing and refitting front brake discs 73
- Removing and refitting rear brake disc 73
- Integral abs removing and refitting front abs sensor 74
- Integral abs removing and refitting rear abs sensor 75
- Removing and refitting brake master cylinder 76
- Removing and refitting foot brake lever 76
- Checking and adjusting piston rod play 77
- Removing and refitting brake piston in handlebar fitting 77
- Integral abs removing installing the abs pres sure modulator 78
- Removing the abs pressure modula tor 78
- Installing the abs pressure modulator 79
- Bleeding wheel circuits 80
- Integral abs draining brake system 80
- Bleeding control circuits 82
- Filling control circuits 83
- Integral abs filling the brake system 83
- Max min 85
- Integral abs removing installing wheel circuit reservoir bleed lines 90
- Removing installing brake lines 91
- Integral abs removing installing brake lines 92
- Removing and refitting front brake line 93
- Removing and refitting rear brake line 94
Похожие устройства
- Stiga SP 350 Q Инструкция по эксплуатации
- BMW R1150RT ABS (2001) Инструкция по эксплуатации
- Stiga SP 352 Инструкция по эксплуатации
- BMW R1150GS (2000) Инструкция по эксплуатации
- Stiga SP 355 Инструкция по эксплуатации
- BMW R1100S (1999) Инструкция по эксплуатации
- Stiga SP 380 Q Инструкция по эксплуатации
- BMW R1200C (1999) Инструкция по эксплуатации
- Stiga SP 382 Инструкция по эксплуатации
- BMW R850C (1999) Инструкция по эксплуатации
- Stiga SP 400 Инструкция по эксплуатации
- BMW R100R Инструкция по эксплуатации
- Stiga SP 400 Q Инструкция по эксплуатации
- BMW R80GS Инструкция по эксплуатации
- Stiga SP 420 Инструкция по эксплуатации
- BMW K1200RS Инструкция по эксплуатации
- Stiga SP 422 Инструкция по эксплуатации
- Stiga SP 440 Инструкция по эксплуатации
- BMW R850 1100R (2000) Инструкция по эксплуатации
- Stiga SP 442 Инструкция по эксплуатации
Скачать
Случайные обсуждения