BMW R1150R ABS (2001) [55/95] Integral abs changing bleeding brake fluid in control cir cuit

BMW R1150R ABS (2001) [55/95] Integral abs changing bleeding brake fluid in control cir cuit
00.50
34 00 091 [Integral ABS] Changing/
bleeding brake fluid in control cir-
cuit
Change brake fluid in control circuit every
2years
(Inspection IV)
d Warning:
All repair and maintenance work on the
BMW Integral ABS should be carried out by special-
ly trained personnel.
Maintenance and repair procedures and processes
should be strictly observed.
Use only new brake fluid from an unopened contain-
er.
34 00 072
[Integral ABS]
Bleeding/changing brake fluid in front
control circuit
d Warning:
Avoid rapid and forceful pumping of the brakes
when performing maintenance and repair work on
the BMW Integral ABS.
Place the motorcycle on its side stand and turn
the handlebars all the way to the left.
Repeatedly and slowly pull the front brake
lever lightly to expel air from brake master cylin-
der.
Place motorcycle on its centre stand.
Remove fuel tank.
Place the front wheel and the handlebars such
that the brake fluid expansion tank is level.
Tighten the handlebar and secure the front wheel
in this position.
e Important:
Do not allow brake fluid to come into contact with
painted motorcycle parts as brake fluid destroys
paint.
Wrap a cloth around the expansion tank.
Remove front reservoir cap with rubber
diaphragm, draw off the old brake fluid and clean
the reservoir.
Top up the brake fluid level to the MAX
mark (arrow).
Connect the bleed device to the front dosing
cylinder bleed screw (1), but do not switch it on.
d Warning:
When changing and bleeding the control circuit
brake fluid, do not use vacuum extraction.
R21000020
R28340110
1
3
2

Содержание