Honda VTR1000F (1998-2003) — как правильно прокачать сцепление и обслуживать систему [176/377]

CLUTCH GEARSHIFT LINKAGE If a brake bleeder is not available use the following procedure Pump up the system pressure with the clutch lever until the lever resistance is felt Connect a bleed hose to the bleed valve and bleed the system as follows 1 Squeeze the clutch lever open the bleed valve 1 2 turn and then close it NOTE Do not release the clutch lever until the bleed valve has been closed 2 Release the clutch lever slowly and wait several seconds after it reaches the end of its travel Repeat the steps 1 and 2 until air bubbles do not appear in the bleed hose Tighten the bleed valve TORQUE 9 N m 0 9 kgf m 6 5 Ibf ft Fill the reservoir to the upper level mark with DOT 4 brake fluid from a sealed container Install the diaphragm set plate reservoir cap and stopper plate and tighten the stopper plate screw TORQUE 1 N m 0 1 kgf m 0 7 Ibf ft CLUTCH MASTER CYLINDER CAUTION Avoid spilling clutch fluid on painted plastic or rubber parts Place a rag over these parts when ever the system is serviced When removing the oil holt cover the end of the hose to prevent contamination DISASSEMBLY Dram the clutch page 9 4 fluid from the hydraulic system Disconnect the clutch switch connectors Disconnect the clutch hose from the master cylin der by removing the oil bolt and scaling washbrs Remove the master cylinder and the master cylinder holder bolts holder