Honda VTR1000F (1998-2003) — инструкция по диагностике тахометра и датчика скорости [355/377]

LIGHTS METERS SWITCHES Coat a naw O ring with oil and install it onto the speed sensor Install the speed sensor in the reverse order of rc moval NOTE Route the speed sensor wire properly page 1 18 TACHOMETER SYSTEM INSPECTION 98 00 Tachometer does not operate properly 1 Remove the three bolts and the combination meter assembly from the stay page 19 7 2 Check the continuity between wire terminal and body ground There should be continuity the green black If there is continuity go to step 3 If there is no continuity check for an open circuit in the green black wire 3 Turn the ignition switch ON and measure the voltage between the hlack brown and green black wire terminals There should be battery voltage If there is battery voltage go to step 4 If there is no voltage check for an open circuit in the black brown wire 4 Connect the peak voltage tester or adaptor probes to the yellow greeri wire termina I and ground TOOLS Peak voltage tester U S A only or Peak voltage adaptor 07HGJ 0020100 with commercially available digital impedance 10 MQ DCV minimum Start the engine signal peak voltage and measure multimeter the tachometer PEAK VOLTAGE 10 5 V minimum If the measured value is more than 10 5 V replace the tachometer page 19 7 If the measured value is less than 10 5 V replace the ignition control module ICM If there is no voltage check for an open or short circuit in the yellow green wire