Honda VTR1000F (1998-2003) — проверка работы тахометра и связанных приборов [356/377]

LIGHTS METERS SWITCHES INSPECTION After 00 Tachometer does not operate properly 1 Check that the speedometer coolant temperature gauge and fuel gauge function properly If they do not function properly check the power source line and sensor ground line page 19 9 If they function properly go to step 2 2 Remove the combination meter assembly page 19 8 Connect the peak voltage tester or adaptor probes to the yellow green wire terminal of the combination meter connector and ground TOOLS Peak voltage tester U S A only or Peak voltage adaptor 07HGJ 0020100 with commercially available digital multimeter impedance 10 M Q DCV minimum Start the engine and signal peak voltage measure the tachometer PEAK VOLTAGE 10 5 V minimum If the measured value is more than 10 5 V replace the meter gaugc assembly page 19 9 If the measured value is less than 10 5 V replace the ignition control module ICM If there is no voltage go to step 3 3 Remove the seat cowl page 2 2 Disconnect the ICM connector Check the yellow green wire for an open or short circuit as follows Check for continuity between the combination meter and ICM connectors There should be continuity Check for continuity tn ground There should be no continuity If the yellow green wire is OK replace the ICM