Honda VTR1000F (1998-2003) — проверка и диагностика датчиков скорости и комбинационных приборов [354/377]

LIGHTS METERS SWITCHES INSPECTION After 00 Speedometer does not operate properly 1 Check that the tachometer coolant gauge and fuel gauge function properly temperature If they do not function properly check the power source line and sensor ground line If they function pioperly go to step 2 2 Remove the combination meter assembly from the stay page 19 8 but do not disconnect the connector Shift the transmission into neutral and turn the ignition switch ON Measure the voltage between the pink green wire terminal of the combination meter connector and ground with the connector connected There should be 0 V to 5 V pulse voltage while slowly turning the rear wheel by hand If the pulse voltage appears replace the meter gauge assembly page 19 9 If the pulse voltage dues nut appear check fur an open or short circuit in the pink green wire If the wire is OK check the vehicle speed sensor VEHICLE SPEED SENSOR INSPECTION Remove the seat page 2 2 Turn the ignition switch ON and measure the vol tage between the black brown and green black wire terminals at the speed sensor 3P white connector There should be battery voltage If there is no voltage check for an open circuit in black brown and green black wires Shift the transmission into neutral and turn the igni tion switch ON Measure the voltage between the pink green and green black wire terminals while slowly turning the rear wheel by hand There should be 0 to 5 V pulse voltage VEHICLE SPEED INSTALLATION SENSOR REMOVAL Remove the scat page 2 2 Disconnect the speed sensor 3P white connector Remove the two bolts battery ground cable and speed sensor