Honda VTR1000F (1998-2003) [325/377] Throttle sensor

IGNITION SYSTEM IGNITION TIMING NOTE Read the instructions for timing light operation Start the engine and warm it up to operating tern perature Stop the engine and remove the timing hole cap Connect the timing light to the spark plug wire Start the engine let it idle and check the ignition timing The ignition timing is correct if the F mark on the flywheel aligns with the index mark on the left crankcase cover at idle Coat a new O ring with grease and install it onto the timing hole cap Apply grease the timing hole cap threads Install and tighten the timing hole cap TORQUE 10 N m 1 0 kgf m 7 Ibf ft THROTTLE SENSOR Remove the fuel tank without disconnecting the fuel and vacuum tubes from the fuel valve page 2 4 OPERATION INSPECTION Disconnect the throttle sensor 3P connector Start the engine Connect the throttle sensor connector when the engine speed is 3 500 rpm or above throttle angle is4 12u The engine speed should increase SYSTEM INSPECTION Disconnect the ignition control module ICM con ncctor page 17 5 Measure the resistance between the yellow black and grecn black wire terminals of the wire harness side connector STANDARD 4 6 k 2 20 C 68 F