Honda VTR1000F (1998-2003) — правильная проверка зазора свечи зажигания и регулировка клапанов [52/377]

MAINTENANCE Measure the spark plug gap between the center and side electrodes with a wire type feeler gauge CAUTION _______________ To prevent damaging the platinum coating of the center electrode use a wire type feeler gauge to check the spark plug gap Make sure that the 1 0 mm 0 04 in wire type feeler gauge cannot be inserted into the gap If the gauge can be inserted into the gap replace the plug witli a new one CAUTION Do not adjust the spark plug gap If the gap is out of specification replace with a new one With the plug washer attached screw the spark plug in by hand to prevent corss threading Tighten the spark plug TORQUE 14 Nm 1 4 kgf m 10 Ibf ft Install the removed parts in the reverse order of re moval VALVE CLEARANCE INSPECTION NOTE Inspect and adjust the valve clearance while the engine is cold below 35 C 95 F Remove the front and rear cylinder head covers page 8 3 Remove the timing hole cap and crankshaft hole cap Rotate the crankshaft counterclockwise and align the F T mark on the flywheel with the index mark on left crankcase cover WIRE TYPE FEELER GAUGE