D-Link DGS-1210-28XS/ME [165/519] Power saving commands

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide

147

19 1

POWER SAVING COMMANDS

The Power Saving commands in the Command Line Interface (CLI) are listed (along with the appropriate

parameters) in the following table.

Command

Parameter

config power_saving

mode

[hibernation | led | link_detection | port] [enable | disable]

config power_saving

<range_name 20> time_range2 <range_name 20> {clear_time_range}

show power_saving

{hibernation | led | length_detection | port}

Each command is listed in detail, as follows:

config power_saving mode

Purpose To configure the power saving mode on the switch.

Syntax

config power_saving mode [hibernation | led | link_detection |

port] [enable | disable]

Description

The config power_saving mode command is used to configure the

power saving mode on the switch.

Parameters

hibernation – Configure the hibernation state to enable or disable.

The default value is disabled.

led – Configure the led state to enable or disable. The default value

is disabled.

link_detection – Configure the link detection state to enable or

disable. The default value is disabled.

port – Configure ports state to be enabled or disabled.

[enable | disable] – Enable or disable the power saving feature.

Restrictions Only Administrator or operator–level users can issue this command.

Example usage:

To configure the power saving mode on the switch:

DGS-1210-28MP/ME:5# config power_saving mode port hibernation enable

Command: config power_saving mode port hibernation enable

Success.

DGS-1210-28MP/ME:5#

config power_saving

Purpose To configure the power saving on the switch.

Syntax

config power_saving [hibernation | led [all | <portlist>] | port [all